Instruction manual

Euphonix Modular I/O Configuration Guide Product Description

Sync in (BNC), Word Clock out (BNC), ~300 mA, 4HP,

~200g.

1.2.5 SY983 Sync

General Description

The SY983 contains an internal clock and can lock to

external AES Sync, Word Clock, Video signal, or Tri-Level

Sync. Internal sample rates are 44.1k, 48k, 88.2k, and 96k.

The module features a sync redundancy mode which allows

two modules, designated master and slave, to be fitted into a

rack. If the master loses sync, the slave automatically takes

over. SY983 Sync modules must be fitted into any of the

four reserved slots on the rear-plane. On-board switches

are used for certain settings including device ID. Web-

browser interface via FC972 Remote provides access to

module status and settings.

Note: The SY983 Sync module should only be

removed from a frame after the frame has been

powered down. Possible damage may occur to some

I/O modules if the master sync source is removed

from a live frame.

Connections, Power Consumption, Width, Weight

Sync in (BNC), Word Clock out (BNC), ~300 mA, 4HP,

~200g.

1.2.6 FC972 Remote

General Description

The FC972 acts as a TCP/IP interface to the frame’s internal

communications buss. Frames with externally configured

modules (remote preamps, 8-ch embedder/de-embedder,

SY983 Sync) must have an FC972 Remote fitted.

Configuration of this module via serial and/or web browser

interface may be necessary. See the manufacturer’s data

sheet for details.

Connections, Power Consumption, Width, Weight