Instruction manual

Euphonix Modular I/O Configuration Guide Product Data Sheets

FC972 Remote

4/7

Can Buss Termination

Can Buss Termination must be done on either the SY982 Sync or FC972

Remote. Lack of termination or double termination may result in communication

errors in the system.

Software Setup

Setting the IP address

Each frame controller on a network must have a unique IP, subnet mask and

gate way (if necessary). During configuration, FC972 modules are addressed as

IP address: 192.168.0.150 (and upward), subnet: 255.255.255.0, gateway

192.168.0.1. To change this, there are two principal methods, via RS232 or via

network.

IP address setup via RS232

1. Connect a PCs RS232 (COMx) via a 1:1 cable to the module and run

a terminal program e.g. Hyperterminal or Minicom (115,200-8-N-1)

and press ENTER :

2. Select “2: Network configuration” and make the appropriate settings

3. Select “4: Reboot”

IP address setup via network

1. Connect the FC972 via an Ethernet cross over cable to a PC.

2. Change the network setting of the PC to the address room of the

default IP address of the unit, subnet 255.255.0.0.

Note: You will find the factory default IP address on a label at the

controller module (see Installation). This address is valid only if the

module is initialized to factory default settings using the front-panel INIT

button. See Operation.

FC972 Remote