Music Mixer User Manual

System 5-B Digital Audio Mixing System Operation Manual eMix Application

4.2.6 Monitor Patching

The monitor outputs are automatically routed to the MC524 Monitor Controller sup-

plied with System 5-B and are ready to be normalled to the speaker inputs. The monitor

feeds are also available within PatchNet for routing to other destinations, if necessary.

Click on the Console I/O category and the Monitor Busses sub-category. This window

shows all 22 monitor feeds:

Table 4-1 Monitor Bussses

The Cascade inputs allow for direct bus injection prior to the insert point into all mon-

itor signal paths.

4.2.7 Solo Bus and Utility Patching

The Solo Busses sub-category in Console I/O allows custom patching into the stereo

Solo Bus.

The Utility Sources sub-category includes the Oscillator output. The Utility Destina-

tions sub-category includes the Slate In which must be patched to the Talkback mic

feed from the Monitor Interface.

4.2.8 Talkback Signal Patching

The two talkback mics are wired to the MC524 Monitor Controller. They are summed

and amplified to produce a single talkback signal. This analog signal must be fed into

the system through an AM713 Analog to MADI converter.

To send talkback to the busses, this signal must be patched to the Slate Input (in the

Utility Destinations subcategory of the Console I/O category). Note which AM713

analog-to-MADI converter input the talkback signal has been hardwired to and patch

that channel to the Slate Input.

Monitor Busses Format

1–8 Control Room L, C, R, Sl, Sr, Bm, X, Y

9–16 Mon A L, C, R, Sl, Sr, Bm, X, Y

17–18 Mon B L, R

19–20 Mon C L, R

21–22 Mon D L, R