Instruction manual

RF Thermostat (Continued)
PROGRAM MODE - YOUR SETTINGS
Weekdays
Time Period Start Time Heat Temperature (°C)
Period 1 am °C
Period 2 am °C
Period 3 pm °C
Period 4 pm °C
Weekend
Time Period Start Time Heat Temperature (°C)
Period 1 am °C
Period 2 am °C
Period 3 pm °C
Period 4 pm °C
SETTINGS
Change between °C and °F
The thermostat temperature display can be set to °C or °F. The default is °C.
With the thermostat off, press the following sequence of buttons: <P>, <T>, <T> again, <A/M>.
Restore factory default settings
The automatic mode factory default settings can be restored to those found on the previous page.
With the thermostat off, press the following sequence of buttons: <P>, <T>, <T>, <DOWN>. If this button sequence is
successfully executed, the LCD will show ‘rE’ meaning ‘RESET’.
Teaching RF thermostat ID code to control unit
CAUTION: The thermostat has already been programmed with a unique code. Do not attempt to teach the RF
Thermostat ID code unless instructed by the manufacturer.
If instructed by the manufacturer, the following steps outline the procedure.
1. Disconnect power to the Receiver/Controller by turning off the Mains Supply.
2. Wait 30+ seconds, then switch Mains Supply back on.
3. With the thermostat off, press the following sequence of buttons: <P>, <T>, <T>, <UP>. If this sequence is
successfully executed the LCD display will show ‘LC’ (LEARN CODE) for 2 seconds then return to the normal OFF
state display. During this time a special code will be transmitted by the RF Thermostat to the Control Unit, causing
the Control Unit to learn its ID.
Derwent High Efficiency Gas Log Fire
20