Instruction manual

!
WARNING
MAINTENANCE SHOULD BE CARRIED OUT BY AUTHORISED PERSONS ONLY.
ENSURE POWER IS DISCONNECTED BEFORE ANY MAINTENANCE TAKES
PLACE.
Maintenance
Read these instructions
REMOVING THE FASCIA PANELS
Figure (1). Remove screws from lower
fascia panel at either end.
Figure (2). Disconnect connector from
rear of controls, and remove lower fascia.
Figure (3). Remove two screws from the
top part of the outer fascia panel...
Figure (4). ...and remove two screws from
the bottom part of the outer fascia panel.
Figure (5). Remove outer fascia panel. Figure (6). Heater components are now
accessible.
REMOVING THE FAN
Figure (1). Remove screws x 2 from rear
of fan.
Figure (2). Pull fan outwards Figure (3). Fan can be removed and put
to one side with power wire connected.
Derwent High Efficiency Gas Log Fire
26