AS3100 series Owner’s Guide Upright vacuum cleaner; household type Thank you for purchasing your new Eureka vacuum! Important instructions For easy assembly, please take a few moments to read this owner’s guide. If you have questions about your new vacuum, please contact our customer service helpline at 1-800-282-2886. We’re here to help! Promotional code: eurekaad15 Special Offer – receive 15% off parts and accessories when ordering online. Promotion excludes vacuums. www.eureka.
Where to find important vacuum information Keep this information Write the model, type and serial number here: Date of purchase (keep your receipt) _______________ Model number and type ________________________ Serial number _________________________________ Find these numbers on a label on the middle back side of the vacuum cleaner. Refer to these numbers when ordering parts and accessories or if service is needed.
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING ! To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. • Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. • Do not allow to be used as a toy.
What comes in the carton Vacuum cleaner AS3100 Series OWNER’S GUIDE Important safeguards Handle Vacuum back 4 Hose Dust cup Extension wand and crevice tool Dusting brush Eureka Customer Service HELPLINE 1-800-282-2886 Turbo nozzle Some models: Telescopic wand www.eureka.
How to assemble your vacuum cleaner 1 Front view 3 2 4 Back view Place vacuum back on base and push down until it snaps into place. Install hose: Align tabs and push down; twist clockwise to lock. Slide handle onto vacuum back and push down until it snaps. 5a 5b Secure loose end of hose over hose hook. Some models: Secure loose end of telescopic wand over hose hook. Eureka Customer Service HELPLINE 1-800-282-2886 6 Slip crevice tool inside extension wand; store in holder on side of vacuum.
How to identify parts of your vacuum cleaner Some models Handle Turbo nozzle Dust cup latch Cord clip Turbo clip Telescopic wand Airpath selector knob Carry handle Nested crevice tool & extension wand Dusting brush Cord rewind button Power cord Dust cup Height adjustment knob Hose Cord reel Brush roll on/off pedal Power switch Brush roll cover Handle release pedal NOTE: For filter maintenance NOTE: For filter instructions, maintenance see page instructions, 7.
Filter maintenance instructions Dust cup – Empty after each use Belt – Check regularly Press lever to release bottom lid. Debris will empty. Close lid until it clicks. For belt change instructions, go to page 12. Washable dust cup filter (DCF25) – Clean monthly Pull latch to lift up cover. Lift out foam filter and filter screen; shake off dust. Rinse foam filter, screen and dust cup. Dry all thoroughly. Align tabs on filter screen with slots on back of cup. Drop into position.
How to use your vacuum cleaner • Pull out cord to desired length (Fig. 1). Do not pull past red line. Press button to rewind cord. 1 2 3 4 5 6 7 8 • Plug power cord into outlet. • To vacuum floors, turn air path knob to ‘FLOORS’ (Fig. 2). • Turn knob to adjust height for bare floor and Low to High pile carpet (Fig. 3). • Adjust brush roll on/off pedal. Step on pedal to turn brush roll on for carpet or off for bare floors (Fig. 4). • Step on power switch to turn on. Step on again to turn off (Fig.
How to use accessories C A U T I O N When using tools, always place handle in upright position and turn off brush roll. 1 2 3 4 • Place vacuum in upright position (Fig. 1). • Turn air path selector knob to ‘TOOLS’ (Fig. 2). • Step on brush roll pedal to turn off brush roll (Fig. 3). • Remove extension wand from clip and lift out crevice tool (Fig.4). Push narrow end of wand over end of hose. • Push tool onto extension wand or directly onto end of hose (Fig 5).
How to clear a blockage C A U T I O N Make sure vacuum is turned off and power cord is unplugged. 1 2 3 4 If vacuum is not cleaning carpet, air path on vacuum back may be blocked. • Lift latch and pull out dust cup (Fig. 1). • To empty debris, press lever to release bottom lid (Fig. 2). If no suction at end of hose, hose may be blocked. • Remove dust cup. • Turn air path knob to ‘TOOLS.’ • Use finger to check for debris in air path (Fig. 3).
How to maintain turbo nozzle 1 Turn nozzle onto back side. Remove 1 screw. 2 Rotate lower part of cover down over brush and lift off cover. 3 Clear blockage from brush roll area. Use scissors to clip threads or hair. 4 Place cover back into position. Tighten screw. How to maintain brush roll C A U T I O N Make sure vacuum is turned off and power cord is unplugged. 1 How to clean brush roll • Check brush roll periodically and remove debris. • Step on handle release to lower handle (Fig. 1).
How to replace brush roll or belt 1 2 Remove 4 screws from brush roll cover. Lift off cover using rear tabs. Use a Phillips screwdriver to remove 2 screws. 5 4 Remove belt from motor shaft and brush roll. Insert left end of brush roll first. Loop new belt around right end of brush roll and insert right end cap into base. 8 Replace the white latch assembly back into position. Pull up white latch to release the belt assembly and lift straight out. 6 Replace belt around motor shaft.
Problem solving ! Make sure vacuum is turned off and power cord is unplugged. This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts off, proceed as follows: 1) Push the power switch to off and unplug the vacuum. 2) Check the vacuum for a possible source of overheating such as a full dust cup, blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum.
The Eureka limited warranty Eureka warrants this vacuum cleaner to be free from defects in material and workmanship for a term of three years for normal household use. Warranty is granted only to the original purchaser and members of immediate household. This warranty is good for three years from the date of purchase only when the vacuum cleaner is used in the accordance with Eureka operating instructions. Note: refurbished or remanufactured products have a one year limited warranty.
Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.