NEU200 series Owner’s Guide Upright vacuum cleaner; household type Thank you for purchasing your new Eureka vacuum! Important instructions For easy assembly, please take a few moments to read this owner’s guide. If you have questions about your new vacuum, please contact our customer service HELPLINE at 1-800-282-2886. We’re here to help! Eureka stands by our Clean Promise seal. Learn more at www.eureka.com/cleanpromise www.eureka.com www.eureka.
Where to find important vacuum information Keep this information Write the model, type and serial number here: Date of purchase (keep your receipt) _______________ Model number and type__________________________ Serial number_________________________________ Find these numbers on a label on the middle back side of the vacuum cleaner. Refer to these numbers when ordering parts and accessories or if service is needed.
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. • Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. • Do not allow to be used as a toy.
What comes in the carton OWNER’S GUIDE Vacuum cleaner Important safeguards Turbo brush Dusting brush Upholstery tool Crevice tool Handle Accessories may vary depending on which model was purchased.
How to assemble your vacuum cleaner Click! Put the vacuum cleaner main body in the upright position. Loop hose under the hose hook. Store accessories on back of vacuum cleaner. Slide handle into top of vacuum cleaner. Push down until it clicks. Loop hose over hose retainer. Push loose end of hose securely onto hose inlet. Store turbo brush on front of handle. Align brush opening with slot and push to snap tool into clip. www.eureka.
How to identify parts of your vacuum cleaner Handle with wand Cord clip Hose retainer Turbo brush Handle release latch Dust cup release button Carry handle Upholstery tool Dusting brush Dust cup lid Dust cup latch Hose Dust cup Crevice tool Cord rewind pedal Cord hook Cord outlet Hose inlet Power switch Height adjustment knob Brushroll cover For filter maintenance instructions, see page 9 Washable foam filter Belt Filter screen 6 Dust cup Vacuum cleaner Eureka Customer Service HELPLINE 1-80
How to use your vacuum cleaner Grab onto the end of cord and pull it out until the yellow tape is visible. Plug power cord into outlet. Turn height adjustment knob to adjust from bare floors to high pile carpet. Step on the cord rewind pedal to retract the cord when needed. Step on power switch to turn vacuum cleaner on. Step on again to turn off. Empty dust cup after every use Step on front of the floor nozzle and recline the vacuum back from the handle to vacuum floors.
How to use accessories 1 ! CAUTION 2 When using tools, always place handle in upright position. Make sure vacuum cleaner is turned off while attaching tools. Click! • Place vacuum in upright position. • Turn height adjustment knob to highest position. 3 • Pull up on hose connection to release hose end from hose inlet (Fig. 1). • Push end of hose into top of handle and twist clockwise until it clicks (Fig. 2). • Press handle release latch and pull out handle with wand (Fig. 3).
How to maintain dust cup and filters Dust cup – Empty after each use Click! Press release button and lift off dust cup. Hold dust cup over wastebasket Close bottom lid until it and press lever to release clicks. bottom lid. Debris will empty. Washable dust cup filters – Clean monthly Pull dust cup latch to lift up dust cup lid. Lift out foam filter and shake off dust. Rinse foam filter and dry THOROUGHLY. Grip tabs and lift out filter screen.
How to clear a blockage ! CAUTION Make sure vacuum is turned off and power cord is unplugged. If vacuum is not cleaning floors, or if no suction at end of hose, check to be sure air path is not blocked. 1 • Press release button and lift off dust cup (Fig. 1). • Empty debris. Hold over wastebasket and press lever to release bottom lid (Fig. 2). • Check filter and filter screen. Remove any debris and shake off dust. (See maintenance instructions on page 9.) • Loosen end of hose.
How to maintain brushroll ! CAUTION Make sure vacuum is turned off and power cord is unplugged. • Step on floor nozzle to lower handle. • Turn vacuum face down on floor. • To avoid unnecessary service calls, check brushroll for debris. • Use scissors to clip heavy threads or strings. How to maintain turbo brush Grasp collar and twist to unlock cover. Lift cover up. With cover open, use figers or small brush to clear accumulated pet hair from bristles. Close cover and twist collar to lock. www.eureka.
How to replace brushroll or belt ! CAUTION 1 2 3 4 Make sure vacuum is turned off and power cord is unplugged. • Step on floor nozzle to lower the nozzle. • Use Phillips screwdriver to remove 6 screws from brushroll cover (Fig. 1). Lift off cover. Refer to Fig. 7 for location of screws. • Rotate right end of brushroll and lift out (Fig. 2). • Lift out left end of brushroll. • To replace belt, position new belt around motor shaft (Fig. 3).
Problem solving ! Make sure vacuum is turned off and power cord is unplugged. N O T I C E : Thermal cut-off This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts off, proceed as follows: 1) Push the power switch to off and unplug the vacuum. 2) Check the vacuum for a possible source of overheating such as a full dust cup, blocked hose or clogged filter.
The Eureka two-year limited warranty Midea America Corp. (“Eureka”), subject to the terms and conditions herein, warrants this vacuum cleaner to be free from defects in material and workmanship for a term of two years from the date of original purchase when used in accordance with the Eureka operating and maintenance instructions and under normal household usage.
Order genuine Eureka accessories and replacement parts Visit www.eureka.com or call 1-800-282-2886 Image Part name Part # Dusting brush tool E0101 Crevice tool E0102 Upholstery tool E0201 Turbo brush E0208 Washable foam filter E0202 Brushroll E0203B Hose E0204 Belt E0205 Detachable handle E206C Dust cup E207C www.eureka.
Owner’s Guide Do not return to the store, call Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com Eureka stands by our Clean Promise seal. Learn more at www.eureka.com/cleanpromise © 2018 Midea America Corp.
