Installation Guide

IMPORTANT WARNING
Read Carefully before installing the fixture. Keep these
instructions for future reference.
Thoroughly inspect the fixture for any freight damage;
Freight damage should be reported to delivery carrier.
The fixtures must be wired in accordance with the
National Electrical Code and all applicable local codes.
Proper grounding is required for safety.
This product MUST be installed in accordance with the
applicable installation code by an electrician familiar
with the construction and operation of the product.
RISK OF ELECTRIC SHOCK: Make sure power supply is OFF
before installing or cleaning xture. No user serviceable parts
inside. Do NOT use the xture within high humidity conditions.
Keep away from flammable and explosive environment.
Do NOT cover the xture with insulation liner or similar material.
Do NOT install where the xture is loose or only partially
supported.
Do NOT impact or exert pressure on the xture surface face or
rear, as damage might occur.
Suggested minimum clearance is 211mm after installation.
INSTALLATION
WIRING GUIDE
1. Wire input end of the LED driver to supply wires using
connector according to wiring section. Wire connections
must be insulated.
2. Connect the BLACK/BROWN lead to LINE(+) supply
lead.
3. Connect the WHITE/BLUE lead to NEUTRAL/COMMON
(-) supply lead.
4. Connect the GREEN lead to GROUND supply lead.
5. lf any, connect PURPLE/BLUE to 0-10V SIGNAL supply
lead and GREY/WHITE to 0-10V NEUTRAL/REFERENCE
supply lead.
HOOK INSTALLATION
1. Fold the hook up with 90°, make it perpendicular to the Troffer.
2. Bend the end of the hook to the right with 90°.
3. Attach the hook on the housing onto the T-Bar.
INSTALLATION GUIDE
MODEL #: ETF22-35W103sw-2 / ETF24-50W103sw-2
©2020. Euri Lighting | A Division of IRTRONIX Inc. All Rights Reserved
For customer service please call us at 1-310-787-1100
Office Hours: 8:00 a.m. – 5:00 p.m. PST Monday-Friday
E-mail: info@eurilighting.com
Questions?
THIS PRODUCT MAY NOT BE COMPATIBLE WITH ALL DIMMERS, FOR MORE INFORMATION ABOUT DIMMER COMPATIBILITY PLEASE VISIT: WWW.EURILIGHTING.COM
LED Toffer Series | 2x2 Class | 2x4 Class
2 ft x 2 ft. All in One Retrofit Kit
2 ft x 4 ft. All in One Retrofit Kit
PLEASE REVIEW THE INSTRUCTIONS AND WARNINGS LISTED BELOW PRIOR TO PROPER INSTALLATION
LED
Troffer
2 ft. x 2 ft.
2 ft. x 4 ft.

Summary of content (1 pages)