Product Manual

where there is frequent lightning, it is advisable to use surge protectors.
Improper use of the grounding plug can result in the risk of electric shock. Consult a qualified electrician or
service person if the grounding instructions are not completely understood.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Assembly
 Remove the appliance from the packaging and peel off
any protective film from all surfaces.
 Fit the shelf support clips onto the shelf support strips, making sure that the clips for each shelf are of
the same height and that they are securely engaged on the support strip.
 Unwrap each shelf carefully, to prevent damaging their protective coating or surface finish.
 Position the shelves onto the clips.
 Please note the following maximum shelf loading weights ： 20Kg.
Important
Before connecting the unit to a power source, please let it stand upright for approximately 24 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during transportation.
The beverage cooler must be positioned so that the plug is accessible. Release the power cord and move
your beverage cooler to the selected location. The beverage cooler should be installed in a suitable place
where the compressor will not be subject to physical contact.
Important
For freestanding installation, the beverage cooler requires 30mm gap on both sides as well as the rear. This
allows the proper air circulation to cool the compressor and condenser. For built-in installation, the beverage
cooler requires 10mm space on each side and at the top as well as 30mm space at the rear. The air vent at
the front must never be covered or blocked in any way.
Levelling Your Beverage Cooler
Beverage cooler must be levelled before loading your beverages. Your beverage cooler is equipped with 4
adjustable feet to facilitate easy levelling.