Product Manual

OPERATING YOUR BEVERAGE COOLER
1. Turning on your beverage cooler. Plug in and switch on the beverage cooler by pressing on the
power button for a few seconds. When you use the beverage cooler for the first time (or restart the
beverage cooler it has been switch off for a long time), there will be a few degrees variance
between the temperature you have selected and the one indicated on the LED readout. This is
normal and it is due to the length of the activation time. Once the beverage cooler is running for a
few hours everything will stabilize.
Important
If the unit is unplugged, power is lost or switched off, wait 3 or 5 minutes before restarting the unit.
The beverage cooler might not start if you attempt to restart before this time delay.
2. Operating noises. To reach the desired temperature settings, Euro beverage cooler, like all beverage
coolers operating with compressors and fans, may produce the following types of noises. These noises
are normal and occur as follows:
Gurgling sound, caused by the refrigerant flowing th
rough the appliance’s coils;
Cracking/popping sounds, resulting from the contraction and expansion of the refrigerant gas to
produce cold;
Fan operating sound, to circulate the air within the beverage cooler.
3. Loading your beverage cooler. You might load your cans or bottles standing or lying in single or
double rows while taking note of the following:
If you do not have enough cans or bottles to fill your beverage cooler, it is better to distribute them
throughout the beverage cooler to avoid “all on top” or “all below” type loads.
Remove or relocate metal racks to accommodate large type of cans or bottles where necessary.
Keep small gaps between the wall and the cans or bot
tles to allow air circulation.
To facilitate air circulation, do not over load your beverage cooler.
Avoid obstructing the internal fan (located inside on the back panel of the beverage cooler)
To prevent the cans or bottles from falling, do not try to slide the racks outwards beyond the fixed
position.