rangehoods USAGE AND CARE GUIDE PRODUCT CODE: EA90STRS2 EA60STRS2
CONTENT Notice 3 Installation Requirements 4 Installation - Fitting the 5 Rangehood Safety Warning Instructions for Use Maintenance Troubleshooting 7 8 10 11
(1) Notice 1. Thank you for choosing our Rangehood. Please read this instruction manual carefully before use. 2. The installation work must be undertaken by a qualified and competent installer in compliance with applicable Australian Standards. 3. Euro Appliances disclaims all liability for any damage or injury caused as a result of not following these instructions for installation. This Rangehood is suitable for connection to a 240V, 50Hz power supply with a proper earth.
(2) Installation - Requirements Warning: This Rangehood is suitable for indoor installation only in accordance with the following: Installation must be performed by a qualified competent installer. If installed above a cooking appliance, the minimum distance from the cooking surface is 65cm,and the maximum distance is 75cm. 150mm . diameter of duct needs to be used for ventilation. 1.
(3). Installation – Fitting the Rangehood. This Rangehood must be placed at a distance of 65cm minimum from the cooking surface of a cooker/hotplate. 3.1 Fit the plastic outlet with flaps to the outlet vent of the Rangehood using 4 sx~crews 9mm long supplied (refer to Pic 2) for location of the flaps. 3.2 Fit the supplied Hook to the wall using the 36mm long screws supplied (refer to Pic 1). Fixing method to the wall must be capable of supporting the weight of the Canopy.
Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. After installation, make sure that the canopy is level to avoid grease collecting at one end.
(4) Safety Warning This Rangehood is for domestic use only, it is not suitable for commercial purposes. Please ensure that installation is performed by a qualified competent installer. The Rangehood and its filter mesh should be cleaned regularly in order to keep it in good working order. Before cleaning, please switch the power off at the main supply. Clean the Rangehood according to the instruction manual. There is a fire risk if cleaning is not carried out in accordance with the instructions.
(5) Instructions for Use – LCD Touch Control 1. Switch on the power to the Rangehood. The backlight is lit displaying a 24 hour clock and the Rangehood is in standby mode. The backlight disappears automatically after 30 seconds if no icons are touched. When the backlight is not illuminated, the Rangehood is off. Touch any key and the backlight will illuminate. 2. To switch on the lights, touch any key to enter standby mode. Touch key, the symbol will appear on the LCD screen.
5. 6. To set the clock, touch any key to enter standby mode. ① Touch and hold timer key for 2-3 seconds, the first two segments of the LCD screen will flash. Touch key to increase the hour setting and touch key to decrease. Note: hour can be set from 00 to 23. ② When the correct hour is set, touch the timer key , the second two segments of the LCD screen will flash. Touch key to increase the minute setting and touch key to decrease. Note: minutes can be set from 00 to 59.
(6) Maintenance 6.1 Cleaning the filters The filters are made of stainless steel baffles. Please do not use corrosive or abrasive detergents to clean the filters. Keeping the filters clean will keep the appliance running correctly. Please strictly follow the guidelines below. Method 1: Put the baffle filter into a sink of clean water, pour on detergent, and soak for 2-3 minutes. Wear gloves and clean with a soft brush. Method 2: Wash in a dishwasher with the temperature set to around 60 degrees.
(7) Troubleshooting Warning: Service must be performed by an authorised competent person. Cause Fault The flaps are blocked Light on, but motor does not work Light does not work, motor does not work Solution Remove the blockage. The capacitor is damaged Th Call for service. The motor is jammed due to bearing damage Call for service. There Th is a bad smell coming m frothe motor Call for service. Bes The above mentioned, check the following: Lig Call for service.
The Rangehood inclines The fixing screws are not tight enough Notify your installer. The hanging screws are not tight enough Notify your installer.
Pronto Service + Support: 1800 440 335 Email: service@eurostylegroup.com.au HEAD OFFICE 65 Glynburn Road, Glynde SA 5070 Ph: 08 8165 1012 www.euroappliances.com.