Product Manual

10
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using war
m soapy water. Ensure the cloth is
clean and well wrung before cleaning. Use a dry soft cloth to remove any excess
moisture left after cleaning.
Important
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives,as this will affect the appliance
appearance and potentially remove any printing of artwork on the control panel and
will void manufactures warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minute in water with a
grease-loosening detergent then brush it gently with a soft brush. Please do not apply
too much pressure, avoid to damage it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. it is advisable
not to use rinse aid.
INSTALLING GREASE MESH FILTERS
• To install filters for the following four steps (See pic below):
- Angle the filter into slots at the back of the hood.
- Push the button on handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters
BULB REP
LACEMENT
Important :
 The bulb m
ust be replaced by the manufacturer, its service
agent or similarly qualified persons.
 Always switch off the electricity supply before
carrying out any operations on the appliance. When handling
bulb, make sure it is completely cool down before any direct
contact to hands.
 When handling globes hold with a cloth or gloves to ensure
perspiration does not come in contact with the globe as
this can reduce the life of the globe.
Note:
• B
efore changing the lights, make sure that the appliance is plugged off.
• Protect against danger when changing lights, such as wearing gloves.