RANGE HOOD USEGE AND CARE GUIDE PRODUCT CODE: EBB900SS2
CONTENT 1 .................................................. Notice 2 .................................................. Installation Requirements 3 .................................................. Installation – Fitting the Canopy. 4 .................................................. Safety Warning 5 .................................................. Instructions for Use 6 .................................................. Maintenance 7 ..................................................
(1) Notice 1. Thank you for choosing our Alfresco Canopy. Please read this instruction manual carefully before use. 2. The installation work must be undertaken by a qualified and competent installer in compliance with applicable Australian Standards. 3. Euro Appliances disclaims all liability for any damage or injury caused as a result of not following these instructions for installation. This Alfresco Canopy is suitable for connection to a 240V, 50Hz power supply with a proper earth.
(2) Installation - Requirements Warning: This Canopy is not an outdoor appliance but it can be installed in an alfresco area in accordance with the following: Installation must be performed by a qualified competent installer. The canopy must not be exposed to rain, moisture or dust. Do not install in a location where winds may blow water or dust onto the canopy. If installed above a barbecue, the minimum distance from the cooking grid/plate is 120cm.
(3). Installation – Fitting the Canopy. The Alfresco Canopy must be placed at a distance of 65cm minimum from the cooking surface of a cooker/hotplate and 120cm minimum from the cooking surface of a BBQ. 3.1 Fit the plastic flaps to the outlet vent of the canopy by deforming the flaps slightly so that the ends fit into the holes (refer to Pic 3 for location of the flaps). 3.2 Fit the supplied Hook to the wall using the 36mm long screws supplied (refer to Pic 1).
Note: Fix the Canopy with two 30mm safety screws. The two safety screw holes are positioned on the back casing (refer to Pic 5). Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. After installation, make sure that the canopy is level to avoid grease collecting at one end.
(4) Safety Warnings This Canopy is for domestic use only, it is not suitable for commercial purposes. Please ensure that installation is performed by a qualified competent installer. The Canopy and its filter mesh should be cleaned regularly in order to keep it in good working order. Before cleaning, please switch the power off at the main supply. Clean the Canopy according to the instruction manual. There is a fire risk if cleaning is not carried out in accordance with the instructions.
（5） Instructions for Use Switch on the power to the Canopy. 1. Press power button, its indicator light will turn on, the hood works at low speed. Indicator light of low speed will be bright. Press power button again to close it, and its indicator light will be off. All the function operation of the hood will be closed, the hood enters into standby mode, and run by circle. 2. Press the Low Speed button, motor runs on low speed, the indicator light of low button and power button will beam.
(6) Maintenance 6.1 Cleaning the filters The filters are made of stainless steel baffles. Please do not use corrosive or abrasive detergents to clean the filters. Keeping the filters clean will keep the appliance running correctly. Please strictly follow the guidelines below. Method 1: Put the baffle filter into a sink of clean water, pour on detergent, and soak for 2-3 minutes. Wear gloves and clean with a soft brush. Method 2: Wash in a dishwasher with the temperature set to around 60 degrees. 6.
(7) Troubleshooting Warning: Service must be performed by an authorised competent person. Fault Light on, but motor does not work Light does not work, motor does not work Oil leakage Vibrations Insufficient suction The Canopy inclines Cause Solution The flaps are blocked Remove the blockage. The capacitor is damaged Call for service. The motor is jammed due to Call for service. bearing damage There is a bad smell coming Call for service.
