EVR60FVSS
Information and advice A) There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels. B) Do not check the status of the filters while the cooker hood is operating. C) Do not touch the light bulb within half an hour after appliance use. D) Do not flambé under the cooker hood. E) Avoid opening gasometer when there is no pan on the stove, as it is damaging for the filters and a fire hazard.
K) This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. L) Children shall not play with the appliance. M) Cleaning and user maintenance shall not be made by children without supervision.
U) Regarding the instructions for the blub replacement, thanks to refer to the section “Replacing Bulb”. V) Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. W) The appliance uses 4 hob elements at most. CAUTION: Accessible parts may become hot when used with cooking appliance. Please keep this instruction booklet in a safe place for future reference.
Installation Ensure the power has been turned off before beginning this installation. Plug must be assembled in places easy to drag and insert . To install this hood you will require two assistants. You will need the following tools and material to complete this installation: *Drill*Flat head screwdriver *Phillips head screwdriver or cordless drill and Phillips head bit*Tin snip* *measuring tape*hand saw or jig saw* electrical tap*duct tape 1. Remove the range hood from the carton. 2.
Method 1 1. According to the figure, make sure the position of hood in the cabinet. The wood strips should be line up with the 4 keyholes slots on the top of the range hood. On the cabinet, install 4 screws(supplied) according to the relative position of 4 key holes on the bottom of hood. The extent of screwing should be convenience to the next installation. 2. Hang the hood and let it’s 4 key holes aim at screws, the 4 screws should be in the narrow parts of key holes.
Method 2 In the installation surface in cabinet don’t adapt to install the cooker hood, then as per fig, fix the position of cooker hood on the wall. On the wall, install 2 screws(supplied) according to the relative position of 2 key holes on the back of hood. The extent of screwing should be convenience to the next installation. Also install screws in the security holes, in case of front and back moving of hood, so that the using is safer.
Check valve Installation Hold on check valve with your hands, align the box gap, put in the check valve , and then spin to a certain angle until three angles of the valve are stuck. Installation is complete. Carbon Filter Activated carbon filter can be used to trap odors.Normally the activated carbon filter should be changed at three or six months according to your cooking habit.The installation procedure of activated carbon filter is as below. - Slide the drawer assembly of cooker hood.
Hood Using Method Operation Check beforehand Check the safe condition of the appliance: - Check whether there are visible defects. - Check that all parts of the appliance have been securely fitted. Switching on/off - Slide the front part of the cooker hood. · There are 3 speeds for the motor and on off switch for the lamp. - Slide the switch for operation.
Clean ventilation fans frequently. Grease should not be allowed to accumulate on fan or filter. Cleaning Instruction Disconnect range hood from power supply before cleaning or servicing. 1. Cleaning the surface of hood frequently. Use mild soap or detergent to clean the hood. 2. Do not use harsh alkalis or abrasives 3. Avoid the use of scouring powers or dishwasher compounds. 4. Grease filter may be washed using mild soap or detergent.
It is recommendable to clean the metallic filter every three months by carrying out the following instruction: —Remove the metallic filter from the cooker hood and wash it in a solution of water and neutral liquid detergent, leaving to soak —Rinse thoroughly with warm water and leave to dry. —The metallic filter may alter in color after several washes. This is not cause for customer complaint or replacement of metallic filter.
The manufacturer shall decline all responsibility if the foregoing recommendations and instruction regarding installation, maintenance and use are not observed and respected when using the cooker hood.