User's Manual

Remark:
- In standby mode, the microphone will still have a small consumption (less the 1.8
microwatts).
- In order to extend your battery life, it is highly recommended to switch “OFF” your
microphone when not using for a long time.
FUNCTION CONTROLS
Adjust the Function Controls as recommended:
A. Tone Control
“H“ for High Tone.
“L” for Low Tone.
B. ASP Control
ON = Echo and Feedback Canceller.
OFF = Echo Reducer only.
C. Adjustable Mike Gain(MIC) Control
“H” for high gain ; “L” for low gain.
Microphone gain "L" is necessary in noisy background.
The Mike gain must be adjusted to match with your cell phone model. If the gain is
too high, it can cause feedback (whistling sound), echo or background noise during
calls on some cell phones.
SETTING THE VOLUME
There are two volume controls on the unit. One is on the main unit (10) and controls only
the main speaker (6). The other is on the headset (8) and sets both the earphone (11)
and the main speaker (6).
The headset volume control (8) is digital and is combined with the multi-function button.
Pressing it clockwise increases the volume. Counter-clockwise decreases it. Continuous
pressing of the digital volume control can also rapidly set the volume.
During a communication, pick-up the earphone and adjust it’s volume (8). Replace the
earphone on the base and adjust the speaker volume (10).
If the volume is too high, it can cause feedback (whistling sound), echo or background
noise during calls on some cell phones.
ANSWERING / RECEIVING A CALL
When phone is receiving a call, the phone ring tone will be heard on the hands-free kit or
on the headset. Just press the button (4 on the main unit, 8 on the headset) once to
answer the call. Pressing the button again will hang-up and terminates the call.
MAKING A CALL
Calling through the hands-free kit can be done using voice tags (refer to the phone user
manual on saving and activating voice tags). The steps are:
1. Press the button (4) once on the main unit or the headset button (8) to activate the
voice dialing.
2. A beep will then be heard prompting the user to say the name of the person to call.
3. Say the name.
4. The phone will then place the call automatically. In case the phone does not
recognize the name spoken, the steps above may be repeated.
5. Press the button again to terminate the call.
If the desired number to be dialed has no voice tag, normal dialing can also be done using
the keypad on the phone. After dialing, audio is transferred automatically to the unit.
When connected, pressing the button (4 or 8) will hang-up and terminates the call.
OPERATING MANUAL
MULTI-TOOTH
Bluetooth Enabled Hands-Free Kit /
Headset
Recommended Function Controls
Setting (Working on all models):
MIC = L
ASP = ON
TONE = H
Note
:
On high background environment,
If you experience audio level
fluctuation, turn ASP ‘’ OFF ’’.
CHANGES OR MODIFICATIONS NOT EXPRESSLY 
APPROVED BY THE PARTY RESPONSIBLE FOR 
COMPLIANCE COULD VOID THE USER'S 
AUTHORITY TO OPERATE THE EQUIPMENT.