Installation Guide and Users Manual SPAGNA VETRO 168 Series 236536 IMPORTANT: Read and save these instructions.
Important Safety Notice Read all Instructions before Installing and operating this appliance • • • • • The installation in this manual is intended for qualified installers, service technicians or persons with similar qualified background. Installation and electrical wiring must be done by qualified professionals and in accordance with all applicable codes and standards, including fire-rated construction. DO NOT attempt to install this appliance yourself.
Important Safety Notice Read all Instructions before Installing and operating this appliance • • • Clean ventilating fan frequently. Always use appropriate cookware and utensils size. Always use cookware appropriate for the size of the surface element. To reduce the risk of injury to persons in the event of a stove top grease fire: • • • SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn OFF the burner. BECAREFUL TO PREVENT BURNS. NEVER PICK UP A FLAMING PAN—you may be burned.
Table of Contents INSTALLATION Tools needed....................................................3 Parts supplied...................................................4 Venting requirements.......................................5 Mount heights & clearance...........................5-6 Calculating vent system length.......................6 Venting methods & ductless conversion..........7 Charcoal filters & electrical requirements.......8 Preparation......................................................
Parts supplied: Range g Hood (vary with model) m Flappers Aluminum Filter(s) () Mounting Bracket Lower standard chimney (Not supplied with re-circulating kit) Upper standard chimney Flexible Duct Tube Air diverter Charcoal Filter (Optional re-circulating kit) (Optional re-circulating kit) Description Toggle Bolts Duct Set Body Hook Chimney Mounting Bracket This Guide and Warranty Card 5mm x 16mm Screw with Washer 4mm x 16mm Tapping Screw 4mm x 10mm Tapping Screw Optional: Toggle Bolt with Tappin
Venting Requirements • • • • • • • Vent system must terminate to the outside (roof or side wall). DO NOT terminate the vent system in an attic or other enclosed area. DO NOT use 4” (10.2 cm) laundry-type wall caps. Use metal/aluminum vent only. Rigid metal/ aluminum vent is recommended. DO NOT use plastic vent. Always keep the duct clean to ensure proper airflow. Calculate the following figures before installation: 1. Distance from the floor to the ceiling. 2.
IMPORTANT: • A minimum of 6” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separately) must be used to maintain maximum airflow efficiency. • Flexible 6” round duct provided for convenience, always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to provided duct. • Please use Duct Run Calculation below to compute the total available duct run when using elbows, transitions and caps.
Venting Methods • • This wall range hood is factory set for venting through the roof or wall. For non-vented (re-circulating) installations, see Recirculating (Non-Vented) Kit on Page 11. Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed. IMPORTANT: • • • • NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside. Use metal/aluminum duct work only.
Charcoal Filter Installation NOTE: The charcoal filters are preinstalled if you purchased the range hood with re-circulating kit from us. 1. Remove aluminum filters on hood. 2. Remove the safety filter under the aluminum filter by unscrewing two screws, then position the charcoal filter and align the screw holes, reinstall and fasten two screws. 3. Reinstall the aluminum filters back to the hood. 4.
Preparation WARNING Excessive Weight Require three or more person to move and install this range hood. Spinal or other bodily injuries could occur if it is not followed. Advanced Preparations: 1. Read the entire installation guide and users manual thoroughly, understand instructions and warnings. 2. Be familiar with the controls of the range hood by reading through Range Hood Operations, Page 13. 3. Place the range hood on a flat, stable surface.
Installation IInstallations t ll ti (refer ( f tto P Page 4 ffor parts): Due to excessive weight, two or more person is recommended for this step. WARNING Excessive Weight 1. Locate an optimal location to place the range hood. Mark the Require three or more person to move and leveling points for two Body Hooks (Figure 1) on the wall and install this range hood. Spinal or other bodidrill two holes with diameter not exceeding 5/8”. Insert two ly injuries could occur if it is not followed.
Installation (Continued) If Recirculating (Non-Vented) Kit is NOT purchased, please go back to step 2 on Page 10. 4. Find an optimal location for the Air Diverter. The air diverter must be placed directly above and align with the two body hooks, see Figure 4. Drill four more holes with diameter not exceeding 5/8” and insert four toggle bolts. Secure the air diverter with four 4mm x 16mm Tapping Screws as shown in Figure 4. Be sure to use appropriate anchors for your wall.
Installation (Continued) 6. Connect the duct tube to the exterior exhaust system or the optional air diverter. Make sure all joints are secure and air tight. Use of duct tape is recommended. 7. Place Upper Chimney and Lower Chimney over the body of the hood as shown in Figure 7A (or Figure 7B of air diverter is present). Slide up the upper duct cover towards the chimney mounting bracket or the optional air diverter.
Range Hood Operations Low Speed Power Switch High Speed Medium Speed Light Switch Turn On: • Press the speed control (Low Speed, Medium Speed, High Speed) switch to select the desired level of power. Once button is pressed, the previous speed mode will cancel. • Press the Light Switch to power on the lights. CAUTION: DO NOT touch the lights until switched OFF and cooled. Turn Off: • Press the Power Switch to turn off the power.
Troubleshooting 1. If the range hood or halogen light does not operate after installation: • • Check if the range hood has been plugged in, make sure that all power has been turned back ON, fused not blown and all electrical wiring are properly connected. Swap out light assembly to working ones to determine whether it is caused by defective bulbs. See Replacing the light bulbs on Page 16. 2.
Use and Care Information Operations: • • • • • Read and understand all instructions and warnings in this manual before operating the appliance. Save these instructions for future reference. Always leave safety grills and filters in place. Without these components, operating blowers could catch on to hair, fingers and loose clothing. NEVER dispose cigarette ashes, ignitable substances, or any foreign objects into blowers. NEVER leave cooking unattended.
Maintenance WARNING SAFETY WARNING: Never put your hand h into area housing the fan while the fan is operating! For optimal operation, clean range hood & all filter/oil container regularly. Hazard of Burns! Light bulb become extremely hot when turned on. Regular care will help preserve the range hood’s performance & appearance. DO NOT touch bulb until switched off and cooled. Cleaning Exterior Surfaces: • Clean periodically with hot soapy water and clean cotton cloth.
Warranty TO OBTAIN SERVICE UNDER WARRANTY: Yoou mu Y You must st pre rese sent se nt prooff of of or oriig igin inall purch chas has asee da date date te.. Plea Pl ease se provi vid ide de aann or oriig igin inall dattedd prooff of of pu p rc rchhase hase (sa salles les re rece ceiip ipt / invo invoiic ice)) in in or ordder der to to obt obtai ain in se serv rviice ice un undder der wa warr rran antty ty. One Year Parts Warranty: For one year from the date of original purchase, Euro-Kitchen, Inc.
Disclaimer Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and signature of the carrier’s agent and keep copy to support your claim. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damages to the carrier and file a claim immediately. Failure to do so may result in the denial of your claim. The carrier will furnish you with necessary forms for filing a claim.
Your Notes Page 19
Your Notes Page 20
Your Notes Page 21
Euro-Kitchen, Inc. 2341 Industrial Parkway West Hayward, CA 94545 Ph: 510.266.0099 Fax: 510.266.6630 http://www.euro-kitchen.
