Manual

Cleaning and Oiling
-Cleaning the feed dog-
1. Open the sewing table and looper cover.
21Turn the balance wheel toward you until the needle
goes up to the highest position.
3. Remove the needle plate and presser foot.
4. Using a lint brush (attahed in the accessory box) to
brush around the feed dog.
5. Re-set needle plate and presser foot,
-Cleaning upper knife area-
1. Open the looper cover.
2 Using a lint brush (attached in the accessory box) to
brush the upper knife and lower knife area
Disconnect the machine from the power supply before
cleaning.
-Oiling-
1. Open the looper cove_
2. Apply 2-3 drops of fine quality sewing machine oil to
the parts as indicated.
3. It is recommended to apply oil once a week in normal
use, once in ten hours in continuous use.
2-3 Drops
19