Instruction manual

GB
86
The Walking Foot Accessory (Optional)
c
a
d
a
b
e
f
1
2
3
*Thewalkingfootaccessoryisoptional.Itisincluded ONLY
with Model 7130 Q. For Models 7130 & 7130 S available through
It is easier to guide the fabric and you have a better view of
the seam when using the standard, regular foot on your
machine.Yoursewingmachineoffersexcellent stitch
qualityonawiderangeoffabricsfromdelicate
chiffons to multiple layers of denim.
The "Walking foot" accessory equalizes the feeding of the
upper and lower layers of fabric and improves the matching
of plaids, stripes and patterns. This foot helps to prevent
uneven feeding of very difficult fabrics.
1. Lift the presser foot bar.
2. Remove the "foot holder" by opening counter clockwise
the presser bar attaching screw. (3)
3. Attach the "walking foot" to the machine in the following
way.
i) The fork arm should fit into the needle screw and
clamp. (2)
ii) Slide the plastic "attaching head" from your left to right
so that it is fitted into the "presser foot bar".
iii) Lower the "presser foot bar".
iv) Replace and tighten clockwise the "presser bar
attaching screw".
4. Make sure both the "needle screw" and the "presser bar
attaching screw" are tightly secured.
5. Draw the bobbin thread up and place both the bobbin
thread and the needle thread behind the walking foot
attachment.
a. Fork arm
b. Attaching head
c. Needle bar
d. Needle screw & clamp
e. Presser foot bar
f. Presser bar attaching screw
Alwaystrytosewfirstwithoutthewalkingfoot
accessory which should be used only when necessary.
EURO-PRO Operating LLC.