OWNER'S MANUAL Model VPW43 cod. 7.100.1132 01/2004 120V., 60 Hz., 12.5 Amps. For information or assistance: EURO-PRO Operating LLC 94 Main Mill Street, Door 16 Plattsburgh, NY 12901 Tel.
SAFETY & WARNING INSTRUCTIONS For safety reasons, it is recommended that you read this manual before attempting to operate this appliance. Failure to follow these instructions can result in personal injury or equipment problems. To help recognize note the following symbols: 9. Keep operation area clear of all persons. 10. Do not overreach or stand on unstable support. Keep good footing and balance at all times. 11. Follow maintenance instructions specified in this manual. 12.
SAFETY & WARNING INSTRUCTIONS TROUBLE SHOOTING PROBLEM POSSIBLE REASON PRESSURE WASHER WILL NOT START WHEN THE ON/OFF SWITCH IS IN THE "ON" POSITION 1. PUMP DOESN'T REACH ADEQUATE PRESSURE OR CAVITATES 1. 2. 3. 2. 3. 4. Electrical socket is faulty or breaker has tripped. Voltage is inadequate. GFCI has tripped. Power cord is not plugged in. 1. 2. 3. 4. 1.
GETTING TO KNOW YOUR PRESSURE WASHER OPERATING INSTRUCTIONS Motor Thermostat Important: This pressure washer is Cleaning Tips Wood Decks: Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent applicator bottle and apply to the area being cleaned. For optimal results, reduce your work area to small sections and clean each section one at a time. Allow the detergent to rest on the surface for a few minutes and then rinse at high pressure.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Cleaning the Nozzles: If you notice that the output pressure fluctuates, you may have to clean the nozzles. Turn the unit "Off". Unplug from electric outlet and disconnect the water supply. Remove the lances, trigger gun and hose from unit. Take the small metal pin provided and insert into the nozzle end to remove any obstructions. (Fig. 15) Using the High Pressure Lance The high pressure lance may be used alone or with the detergent applicator bottle.
OPERATING INSTRUCTIONS Attaching High Pressure Hose to Pressure Washer Assembling the Pressure Washer Trolley (cont) Once the pressure washer is assembled to the trolley, you are ready to use the unit. 1. While facing the front side of the unit attach the high pressure hose to the high pressure output connector on the right side of the unit. Twist on tight to avoid leakage. (Fig. 7) 4. Slide the top brace over the legs and insert the handle assembly onto the top of the legs.