Refrigerator User Manual

10 - COMMISSIONING YOUR CONDITIONER
- Press the key to conrm the new setting, the display then returns to the new setting.
The setting can be adjusted between 9 and 15°C . Beyond this range, the and keys do not work.
WARNING: to operate correctly, your conditioner must be in a location where the ambient
temperature is between -5°C is 35°C.
W hen making signicant modications to temperature settings, it can take several hours for the temperature in your cellar to stabilise and for the conditioner
to display the desired temperature.
VI- Silent function
Your EuroC ave conditioner is tted with a silent function which allows the sound level to be reduced when you enter the cellar.
W hen the conditioner is on:
- Press and hold down the key for 3 seconds.
The display then appears. Next the current temperature is displayed.
You will be able to see this function via the pictogram which ashes for 15 minutes.
The compressor then remains in operation an
d the fans change to slow speed for 15 minutes.
After this, the conditioner returns to the default operating speed.
VII- Heating function
The EuroCave IN OA conditioner has a heater (650 W ) allowing the internal temperature in your cellar to be maintained at an optimal level.
As soon as the temperature drops below the programmed temperature, the heating function is automatically activated.
VIII- Changing the remote control batteries
Remote control power supply: 1 x 3 V (CR 2430 battery) (2 batteries supplied)
Battery life: 2 years approx
The remote control is supplied with 2 batteries. O nly one battery is required (pull o the plastic strip to make it
useable).The other battery is a spare.
- W hen the battery runs out, the pictogram ashes on the remote control’s display.
- Take the remote control o the wall.
- O n the back of the remote control, push the used batt
ery down using a screwdriver (see diagram opposite).
- Pull the strip from the spare battery, which will then be ready for use.
- Remember to buy a replacement for the spare battery.
IX - Discharging condensate
Your conditioner was designed to allow condensate to be discharged (discharge pipe located under the conditioner’s
housing) either inside the cellar, if the humidity level is too low, or outside the cell
ar.
Simply pass the pipe through the wall to discharge the condensate into the room next to the conditioner housing.
Ensure that the piping is not kinked.
20