Instructions
63
c) Testing the function of the weather station and outdoor sensor
You can test the function of the weather station and the outdoor sensor before you install them permanently. The
weather station and the outdoor sensor should not be more than 1.7 m to 3.3 m apart during the rst synchronisation
attempt.
• Establish the power supply to the weather station and outdoor sensor as outlined in chapter ‘10. Operation’.
• If necessary, wait a short while until the signal from the outdoor sensor has been successfully received. You can
simulate wind by turning the wind speed sensor (D) and rain by adding water to the rain funnel (A) to obtain initial
measured values from all sensors.
After installing and testing functionality, erase all recorded data to avoid measuring inaccurate precipitation
and wind data later during regular operation.
• Press and hold the HISTORY button (6) for 10 seconds. This will erase all previously recorded data.
The time and connection to the outdoor sensor (pairing) are not affected. You will not need to reset the time
or pair the weather station and outdoor sensor again.
d) Time display and time setting
1Switching automatic time setting off/on
The device sets the time automatically according to the DCF radio signal that it receives. To set the time and the
calendar manually, you must rst deactivate DCF reception.
1. Press and hold the RCC button (18) for 8 seconds. A beep conrms that it has been switched off. The ‘OFF’ symbol
indicates that automatic DCF reception has been switched off.
2. Press and hold the RCC button (18) for 8 seconds to reactivate automatic DCF reception. A beep sounds as
conrmation. The ‘ON’ symbol indicates that automatic time reception has been activated.
2Setting the time and date/time zone manually
Manual setting of the time and calendar is only necessary if the weather station has not received a DCF
signal.
With this weather station, you can set the time and date manually. Proceed as follows:
1. Press and hold the TIME SET button (14) for 2 seconds to enter setting mode. The 12-hour or 24-hour display
symbol ashes rst.
2. Press the Up button (20) or the Down button (21) to select a setting. The current setting ashes.
3. Press the Up button (20) or the Down button (21) to change a setting value. Press and hold the respective
button to quickly scroll through the digits.
4. Press and hold the TIME SET button to conrm your setting.
5. The setting sequence begins with the hour format and proceeds as follows: 12/24 hour format → Hour → Minute
→ Second→Year → Date (Month → Day) → Hour offset → Language → DST AUTO/OFF The time zone is
changed as an hourly offset. An offset of -23 and +23 hours can be set.