Installation guide

OS-9 V2.4 on EUROCOM-17 7 Additional Libraries
Software Manual 41
Sys$SlavAddr Set VMEbus slave base address
❏ Input:
d0.w = 10 (Sys$SlavAddr function code)
d1.l = VMEbus slave address for standard access
d2.l = VMEbus slave address for extended access
❏ Output:
none
❏ Error Output:
cc = carry bit set
d1.w = error code if error
❏ Possible Errors:
E$Permit - you must belong to group 0 to use this function.
E$Param - impossible address given
❏ Function:
Sys$SlavAddr sets the VMEbus slave base address for both standard
and extended addressing.