User Manual

Modules

Setting Up SATA RAID or AHCI Mode 7 - 5

1. Go to the operable computer and insert a USB Flash drive or external USB hard

disk.

2. Insert the Device Drivers & Utilities + User’s Manual disc into the CD/DVD drive

of the operable computer.

3. Copy the f6flpy-x86 or f6flpy-x64 folder from the location below (D: denotes your

DVD drive) on the Device Drivers & Utilities + User’s Manual disc to the USB

flash drive or external USB hard disk.

• For Windows 8.1 64-bit = D:\Options\RAID\f6flpy-x64

4. Start-up your notebook computer and press <F2> to enter the BIOS.

5. Go to the Boot menu, select UEFI Setting and press <Enter> (see page 5 - 12).

6. Set UEFI Boot to “Enabled”.

7. Press <Esc> to exit the menu and go to the Advanced menu.

8. Select SATA Mode (see page 5 - 8), press <Enter> and select “RAID Mode”.

9. Press <F4> and <Yes> to “Save Changes and Reset”.

10. After computer restarts press <F2> to enter the BIOS again.

11. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and press

<Enter>.

12. Select Create RAID Volume and press <Enter>.

Figure 7 - 1

Create RAID Volume

(Advanced > Intel(R)

Rapid Storage

Technology