Installation Guide

THANK Y O U
You’ve just
purchased a
lighting product
designed and built
to provide you
with many years of
enjoyment.
MERCI
Vous venez
d’acheter un
luminaire conçu
pour vous donner
des années de
plaisir.
GRACIAS
Usted acaba de
adquirir un
excelente producto
de alumbrado
disenado y
construido para
proveerle muchos
años de satisfaccion.
1 2 6 0 8
INSTRUCTIONS
• Please read all instructions prior to installation.
• Installation of this fixture must comply with local building codes.
• Installation of this fixture must be done by a qualified electrician.
• Veuillez lire toutes les instructions avant l’installation.
• L’installation de ce luminaire doit être faite selon le code local de
construction.
• L’installation de ce luminaire doit être faite par un électricien
qualifié.
• Favor de leer toda las instrucciones antes de comenzar la instalacion.
• La instalacion de esta luminaria (este producto) debera de cumplir con los
codigos locales de construccion.
• La instalacion de esta luminaria (este producto) debera ser realizada por
un electricista calificado.
Tools Required • Outils Nécessaires • Herramientas Requeridas
INSTALLATION & CONNECTIONS
IMPORTANT SAFFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
IMPORTANT: Use qualified electrician for installation of this lighting
fixture.
1. Turn off power at main fuse box.
2. Install mounting backplate (A) to junction box with 2 screws supplied. Make
sure black and white wires of junction box run through the middle opening of the
crossbar.
3. Fasten open end of ground wire (bare copper or green wire), to ground wire or
ground screw of junction box or ground screw on crossbar.
4. Connect black wire of power supply to black wire of the fixture and the white
wire of the power supply to the white wire of the fixture. NOTE: All wire
connections should be made with wire nuts or marettes (included) and pushed
back into junction box.
5. Mount canopy of sconce (B) over mounting plate (A) and secure with 2 Top
caps (C) supplied.
GLASS AND BULB INSTALLATION
1. Using a tissue or glove, install 150W max R7S(118mm) Bulb (not included)
otherwise oil from fingers will decrease the life of the bulb drastically.
2. Insert bulb cover over bulb clipping onto socket ends.
3. Fasten open end of ground wire (bare copper or green wire), to ground wire or
ground screw of junction box or ground screw on crossbar.
4. Connect black wire of power supply to black wire of the fixture and the white
wire of the power supply to the white wire of the fixture. NOTE: All wire
connections should be made with wire nuts or marettes (included) and pushed
back into junction box.
TURN ON POWER
ENJOY YOUR PRIMALUCE™ LIGHTING PRODUCT