Installation Guide

• Please read all instructions prior to installation.
• Installation of this xture must comply with local building codes.
• Installation of this xture must be done by a qualied electrician.
• Veuillez lire toutes les instructions avant l’installation.
• L’installation de ce luminaire doit être faite selon le code local
de construction.
• L’installation de ce luminaire doit être faite par un électricien qualié.
• Favor de leer toda las instrucciones antes de comenzar la instalacion.
• La instalacion de esta luminaria (este producto) debera de cumplir con los
codigos locales de construccion.
• La instalacion de esta luminaria (este producto) debera ser realizada por un
electricista calicado.
16339
INSTRUCTIONS
Thank You
You’ve just
purchased a
lighting product
designed and built
to provide you
with many years of
enjoyment.
Merci
Vous venez
d’acheter un
luminaire conçu pour
vous donner
des années de plaisir.
Gracias
Usted acaba de
adquirir un excelente
producto de alumbrado
disenado y construido
para proveerle muchos
años de satisfaccion.
16339/04/08
Tools Required • Outils Nécessaires • Herramientas Requeridas
INSTALLATION & CONNECTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
NOTE: Use a qualied electrician for installation of this lighting xture.
INSTALLATION INSTRUCTIONS
1. Turn off power at main fuse box.
2. Tighten canopy of xture (B) onto center hub (A).
3. Install mounting backplate (C) to junction box with 2 screws supplied.
Make sure black and white wires of junction box run through the middle
opening of the mounting backplate.
4. Fasten open end of ground wire (bare copper) to ground wire or ground
screw of junction box or ground screw on mounting backplate.
5. Connect black wire of power supply to the black wire of xture and connect
white wire of power supply to the white wire of xture. NOTE: All wire
connections should be made with wire nuts or marettes (included) and
pushed back into junction box.
6. Mount canopy of xture (B) over mounting backplate (C) and secure
with 2 caps (D) supplied.
GLASS AND BULB INSTALLATION
1. Slip glass over socket and secure glass by tightening socket ring (E) using
socket ring tool (F) supplied. Do not over tighten.
2. Install 40W Max. G9 bulbs (included) into socket
3. Install bulb cover (G) over socket. Do not over tighten.
TURN ON POWER
ENJOY YOUR EASYLITE™ LIGHTING PRODUCT