User manual

00042012.DOC, Version 1.1
24/33
During a show, the laser product must never be repaired or adjusted in a way that the laserbeam is
c
orrected.
Outside the laser show, the beam must be interrupted closed to the laser or be shut off.
Operating staff
The laser-light-show must only be carried out by a trained person. This person must control the laserbeam
d
uring the show and immediately switch off the device or interrupt the laser beam in case of failure of the
device, unsecure operational conditions or unrest in the audience.
The operator has to make sure that hired persons operating laser products of the classification 2 to 4 are
trained in their behaviour.
For showlasers, the operator has to instruct the hired persons on how to keep the accessible radiation as low
as possible. The hired persons have to carry out these instructions.
At least once in a year, the operator has to make sure that the hired persons are informed upon the dangers
of laser radiation, the existing safety installations and the necessary protective measures if laser products of
the classification 2 to 4 are operated.
The operator has to make sure that only absolutely necessary hired persons can enter into the laser area.
Medical treatment of eye damage
Assuming that laser radiation has caused eye damage, the operator has to make sure that the hired person
will immediately be treated by an eye doctor.
Unintended use/Behaviour in case of failure
This laser product must NEVER be operated by children.
This laser product must NEVER be used at festivals, open-air events, parades etc. Outside operation is
forbidden.
This laser must NEVER be operated, if it is not equipped with all protective measures for a safe operation.
CAUTION!
The use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure!
If the laser beam does not move after switching the device on, the device must immediately be taken out of
operation. Please let the device be checked by a qualified service technician.
Laser products of the classification 2 to 4 must be installed in a way that unintended radiation is avoided.
Unintended radiation is when laser radiation emits from the laser product without using the normal control
elements, e.g. due to damaged isolation or interferences or if it is not avoided that control elements can be
operated unintended.
4. DESCRIPTION
4.1 Features
High-power laser
• Laser with the classification 4
• RGY-colour-mixture
• Operation: MCU, DMX 512, auto, sound-active
• Effects: layers, grids, tunnels, waves, writing, graphics, animation
• Laser diode: 650 nm red, 532 nm green
• Laser safety by key switch for locking startup and connection for emergency off
• Read user manual before use. Laser installation, alignment and operation only by qualified and trained
personell! Never open the housing!