User manual

51930420_V_1_0.DOC
18/37
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the spot to the mains, the EUROLITE LED Bar RGB 252/10 Indoor starts running.
STAND ALONE OPERATION
Control via Dip Switches
In order to adjust the sensitivity during Sound Activated Strobe and Sound Activated Color Change, turn
the rotary-control knob on the back panel of the device.