User manual

51930420_V_1_0.DOC
19/37
DMX-CONTROLLED OPERATION
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing the Projector
Set the dipswitch 10 to ON.
The Control Board on your DMX-controller allows you to assign the DMX fixture address, which is defined as
the first channel from which the LED Bar RGB 252/10 Indoor will respond to the controller.
For address setting, press the Up/Down-buttons until the display shows "A001" and set the desired address
via the Up/Down-buttons.
Controlling:
After having addressed the LED Bar RGB 252/10 Indoor, you may now start operating it via your lighting
controller.
Note:
After switching on, the LED Bar RGB 252/10 Indoor will automatically detect whether DMX 512 data is
received or not. If the data is received, the control LED flashes. If there is no data received at the DMX-input,
the control LED lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of LED Bar RGB
252/10 Indoor.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Channel 1 Function
0 – 10 Dimmer (channel 2-13 dimmer valid)
11 – 51 Strobe (channel 2-13 dimmer valid)
52 – 91 Light on and off (channel 2-13 not valid)
92 – 131 Auto color change (channel 2-13 not valid)
132 – 147 Chase 1
148 – 164 Chase 2
165 – 181 Chase 3
182 – 198 Chase 4
199 – 215 Chase 5
216 – 232 Chase 6
233 – 255 Chase 1 - 6
Channel 2 Dimmer
0 - 255 Red
Channel 3 Dimmer
0 - 255 Green
Channel 4 Dimmer
0 – 255 Blue
Channel 5 - 13 Brightness
0 - 255 From segment 1 to 3 in red, green, blue