User manual

00058443.DOC, Version 1.1
21/23
STAND-ALONE MODE
In Stand-Alone Mode, the LED BAR-12 RGB 12x1W can be used without a controller. Disconnect the LED
BAR-12 RGB 12x1W from the controller.
LED Screen
The LED screen offers several features: you can run the internal programs or set the starting address.
Browse through the main menu by pressing the MODE button.
You can change the selection by pressing UP or DOWN.
The functions provided are described in the following sections.
The display shuts off after 30 seconds of inactivity. With the touch of a button it lights up again.
Setting Solid Colors
Press the MODE button to select the solid color mode. When the LED screen shows C, you can select the
desired solid color via the UP or DOWN buttons (see following graphic).
Mode: Value: Function:
C01 Red
C02 Green
C03 Blue
C04 Cyan
C05 Magenta
C06 Yellow
C
C07 White
Internal Programs
Press the MODE button to select the internal program mode. When the LED screen shows P, you can select
the desired internal program, with or without sound control, via the UP or DOWN buttons (see following
graphic).
Mode: Value: Function:
P1
Endless loop in 7 colors,
change every 3 seconds
P2
Endless loop in 7 colors,
fade every 3 seconds
P3
Endless loop in 3 colors,
change every 3 seconds
P4
Endless loop in 3 colors,
fade every 3 seconds
P5
Endless loop in 7 colors,
via sound control
P
P6
Endless loop in 3 colors,
via sound control
Sound Control / Sensitivity
Press the MODE button until the LED screen shows S. You can select the desired sensitivity via the UP or
DOWN buttons.
Mode: Value
S
S00 - S99 (S50 default)
DMX MODE
The LED screen allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED BAR-12 RGB 12x1W will respond to the controller.