User manual

ManualsBrandsEuroLite ManualsFlood LightLED TMH-7

51786410X84NXS_V_1_2.DOC

30/58

The objective lens will require weekly cleaning as smoke-fluid tends to building up residues, reducing the

light-output very quickly. The cooling-fans should be cleaned monthly.

The gobos may be cleaned with a soft brush. The interior of the fixture should be cleaned at least annually

using a vacuum-cleaner or an air-jet.

The dichroic colour-filters, the gobo-wheel and the internal lenses should be cleaned monthly.

There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service

operations are only to be carried out by authorized dealers.

Please refer to the instructions under "Installing/Replacing the lamp".

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of

same type and rating.

Before replacing the fuse, unplug mains lead.

Procedure:

Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-

clockwise).

Step 2: Remove the old fuse from the fuseholder.

Step 3: Install the new fuse in the fuseholder.

Step 4: Replace the fuseholder in the housing and fix it.

Should you need any spare parts, please use genuine parts.

If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply

cable available at your dealer.

Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply: 230 V/50 Hz

Power consumption: 265 W

DMX-control-channels: 5

DMX-512-connection: 3-pin XLR

Flash-rate: 13 Hz

Colour-wheel: 7 dichroic filters and open

Rotating gobo-wheel: 7 gobos and open

Maximum PAN-movement: 360°

Maximum TILT-movement: 250°

Length of base: 330 mm

Width of yoke: 335 mm

Height (head horizontal): 360 mm

Weight (net): 12 kg

Maximum ambient temperature t

45° C

Maximum housing temperature t

(steady state):

90° C

Min.distance from flammable surfaces: 0.5 m

Min.distance to lighted object: 0.5 m

Fuse: F 5 A, 250 V

Fitting lamps:

OMNILUX OTI 90V/150W GY 9,5 750h 6500K No. 91201395

OMNILUX OTI 95V/152W GY 9,5 2000h 5000K No. 91201396

OSRAM HTI 150W 90V/150W GY9,5 750h 6900K No. 91201327

OSRAM HTI 152W 95V/150W GY9,5 2000h 5000K No. 91201329

Recommended controllers:

EUROLITE DMX Operator No. 70064520

Wizard-512 DMX-Software + Interface No. 51860101

Wizard-1024 DMX-Software + Interface No. 51860110