User manual

51786410X84NXS_V_1_2.DOC
22/58
INSTALLATION
Installing/Replacing the lamp
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
For the installation, you need one HTI 90 V/150 W GY-9.5 lamp.
The lamp must only be changed when wearing appropriate protective clothing (protection glasses, protection
gloves, helmet with sight, leather apron).
The lamp has to be replaced when it is damaged
or deformed due to the heat!
CAUTION!
The lamp life given by the manufacturer must never be exceeded. This is why you need to take notes on the
operational time of the lamp and replace the lamp in time.
Keep exchanged lamp in a protective
container and remove accordingly.
During the operation, the lamp reaches
temperatures of up to 600° C.
Before replacing the lamp, unplug mains
lead and let the lamp cool down (approx.
10 minutes).
During the installation do not touch the glass-
bulbs bare-handed! Please follow the lamp
manufacturer's notes!
Do not install lamps with a higher wattage!
Lamps with a higher wattage generate
temperatures the device was not designed
for. Damages caused by non-observance are
not subject to warranty.
Procedure:
Step 1: Unscrew the fixation screws of the lamp cover and remove it.
Step 2: Unscrew the knurled-head screws of the lamp holder and remove it.
Step 3: If replacing the lamp, remove the old lamp from the lamp holder.
Step 4: Insert the lamp into the lamp holder.
Step 5: Replace the lamp holder and tighten the knurled-head screws.
Step 6: Adjust the lamp as described under lamp adjustment.
Step 7: Replace the lamp cover and tighten the fixation screws.
Do not operate this device with opened cover!