User manual

00054293.DOC, Version 1.1
20/23
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Y
ellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the spot to the mains, the EUROLITE LED Z-200 TCL starts running.
The device has two operating modes. It can be operated via DIP-Switches or it can be run in DMX-controlled
mode.
Please see the following graphic for DIP-Switch settings.
OPERATION VIA DIP SWITCHES
1=on
0=off
X=changeable
Function:
DIP
1
DIP
2
DIP
3
DIP
4
DIP
5
DIP
6
DIP
7
DIP
8
DIP
9
DIP
10
DMX-Mode
Slave-Mode
AutoMode
SoundControlledMode
LEDSpeed1
10
X
X
X
XXX
0
0
0
0
0
000
0
1
1
0
0
1
X
XXXXX
0
0
XX
0
0
X
X
XX
0
0
XX
X
XXXX
1
1
X
Master-Modus
LED 2Speed
X
X
0
1
XXXX
0
0
LED 3Speed
XX
1
0
XXXX
0
0
LED 4Speed
XX
1
1
XXXX
0
0
Red
XX
X
X
X
X
X1
0
0
Green
X
X
X
X
XX1X
0
0
Blue
XX
X
X
X1XX
0
0