User manual
00057262.DOC, Version 1.0
19/23
5. MOUNTING
5.1 Mounting on a stand
For mobile use place the light set on a lighting stand. Suitable items can be found in chapter Accessories.
1. On the stand, loosen the fixation screws of the legs. Pull out the legs until the cross struts stand at a 90°
angle to the legs. Tighten the fixation screws of the legs.
2. Attach the light set via its TV pin on the control unit to the top end of the stand and fasten the fixation
screw.
3. Caution! The load has to be installed in a balanced way. The carrying capacity of the stand must never
be exceeded. The stand must be set up in a stable way. Make sure all fixation screws fit tight.
5.2 Fixing to a truss
The light set can be fixed to a truss using two hooks.
1. Screw down the hooks with both fastening screws located on the upper side of the crossbar.
2. Suspend the hooks in the truss and tighten the fastening screws.
3. Always install a safety bond. Before rigging, make sure that the installation area can hold a minimum
point load of 10 times the device's weight.
5.2.1 Safety instructions
For overhead rigging in public or industrial areas, a series of safety instructions have to be followed that this
manual can only give in part. The operator must therefore inform himself on the current safety instructions
and consider them. The manufacturer cannot be made liable for damages caused by incorrect installations
or insufficient safety precautions!
DANGERTOLIFE!
Pleaseconsiderthe andtherespectivenationalnormsduringthe
installation!Theinstallationmustonlybecarriedoutbyanauthorizeddealer!
DIN15560-27
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.