User manual

00026749.DOC, Version 4.3
12/23
INSTALLATION
Installing/Replacing the lamps
DANGERTOLIFE!
Onlyinstallthelampswiththedeviceswitchedoff!
Unplugfrommainsbefore!
Thelamphastobereplacedwhenitisdamaged
ordeformedduetotheheat!
CAUTION!
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for and can destroy the control portion. Damages caused by non-observance are not
subject to warranty.
For the installation, you need 230 V/60 W E-27 lamps.
During the operation, the lamp reaches temperatures of up to 200° C.
Procedure:
Step 1: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 2: Put the new 230 V/60 W E-27 lamp into the socket.
Rigging
DANGEROFFIRE!
Wheninstallingthedevice,makesurethereisnohighly-inflammable
material(decorationarticles,etc.)withinadistanceofmin.0.5m.
Install the device on a plane surface.
This device features a protective insulation.
In general, lighting effects should not be connected to dimming-packs.
OPERATION
Connect the effect to the mains. With the ON/OFF-switch, you can switch the device on and off. The chaser-
speed can be adjusted via the Speed-control. The speed is also sound-controlled. You can adjust the
microphone-sensitivity via the Music-control.
Attention: Remove the wrapping material around the lamps before operating this device!