User guide

LS Module

the active LS Module fails, then the ESI communication

with the host system will be taken over by the passive LS

Module.

LS Module Features • Monitoring/Control for 2 Power Supplies and 2 ACMs

• Reports status and receives control information via the FC loop

• Microcontroller for data processing, control and communica-

tions

• Volatile and non-volatile memory for the microcontroller

• Temperature sensor

• Audible alarm with manual and software disable

• FC link monitoring and status information

• Firmware download capability

• Reporting of PSU, LS module, I/O module, and backplane

serial number and revision

• I/O module and backplane type reporting

• Control of 6 front LEDs for enclosure and module status

• I/O option slot status monitoring

SANbloc Enclosure

LEDs

The SANbloc Series has six LEDs located on each of the

front mounted LS Modules. These LEDs show the status of

the enclosure, power supply, Fibre Channel Loops, LS

Module status and the operating mode of the enclosure (1GB

or 2GB

operation). Figure 4-1 shows the location of the

LEDs

1. 2GB option is not currently supported