Operation Manual

23
 Place the other end of the flexible hose (with the oval opening) in
the opening in the window panel.
 The unit usually comes with the outlet pipe fitted for the cooling
function: (removing hot air). If you wish to use the heater function,
the cold air must be removed. In order to do so, you must change
the connection: the attachment plate with outlet pipe must change
places with the attachment plate with exhaust fins (and vice
versa). Remove from the Multiclima by pulling upwards and then
replace in the appropriate position, see diagram.
 Avoid kinks or bends in the hose and keep it sloping slightly
upwards. Kinks and bends will lead to a build up of damp, waste
air which can cause overheating or lead to the Multiclimaair
switching off.
 Warning! Do not use your Multiclima until it has been installed
according to the instructions above!
 Warning! The length of the outlet pipe is especially designed to
suit the Multiclima technique. Do not replace or extend it using
another pipe as this could have a negative impact on the
effectiveness of the Multiclima. The hose can be stretched to
150 cm but must be kept as short as possible (max. 40 cm) in
order to ensure optimum functioning.
Make sure that all connections are secured properly, that the unit is
not damaged or broken and that the socket to which you wish to
connect the Multiclima is the same voltage as stated on the device's
specification plate.
If everything is ok, insert the plug into the socket.