Operation Manual

- OFF indicates that the heater has been

switched off by the stand-by button or the topple

safeguard.

- The figures show the temperature

3rd line:

- The time: both the ordinary time and the set

times for the weekly timer.

4th line:

- The days of the week: 1 = Monday, 2 = Tuesday

and so on.

The heater must always be secured to a wall; it may not be used standing up!

Do not use until it has been installed according to the instructions below.

Installation

Remove all packaging material and keep out of reach of children. After removing

packaging, check the appliance for damage or other signs that could indicate a

fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your

vendor for inspection or replacement.

 Choose a solid, flat and completely vertical wall made of non-flammable and non-

melting material on which to mount the heater (i.e. no wood, synthetic materials,

etc!)

 Decide where you want to mount the

heater. Make sure that the heater has

sufficient space around it at all times and

that no inflammable materials are located

nearby (see also safety instructions). Do

not place the heater behind a door! The

heater’s underside needs to be at least

30 cm above the floor, the sides at least

30 cm from the side walls and the top at

least 150 cm from the ceiling, ceiling

beams, etcetera.

 Secure the 2 hanging brackets o the wall. Choose a left and a right bracket and

secure them with the channel to the top, the short sides against the wall and

facing one another (see diagram on page 3). Drill 2 holes in the wall, with a

distance of 255 mm between them. (Alutherm 1000) /

400 mm. (Alutherm 500) / 563 mm. (Alutherm 2000), at

least 61 cm. above the floor and horizontal. Push plugs

into the drilled holes and screw the brackets to the wall

using the 2 large screws.

 Screw the other 2 brackets with the smaller screws

below the heater, in the relevant holes (see diagram):

screw through the long side of the bracket, the short

side facing down. The short side will come to lie

against the wall.

 Hang the heater on both brackets and let it drop into