Operation Manual

29
- Anticipation on or off
- Thermostat setting
- Timer on-time
- Timer off-time
- Next timer setting
o If you would like to delete a specific setting, press and hold WEEK and then
search for the timer setting that you need. Go past 01- ][ and on/off first by
pressing SET briefly. When the number of the timer setting that you wish to
change appears, press SET for a little longer. You will hear a short beep and
the selected setting has been deleted.
o If you wish to delete all timer settings, press the WEEK button and hold. Press
and hold the MOD and SET buttons at the same time, until you hear a beep.
The screen will show 88:88, indicating that all settings have been deleted.
Please Note: all timer settings can only be deleted with the buttons on the
operating panel, not with the remote control!
o If you wish to retain the timer details but do not want to use the timer for a
while, push and hold the WEEK button and then push and hold the MOD until
TIME disappears from the screen to indicate that the data will be retained but
will not be active. By pressing MOD again until TIME appears,
you will reactivate the timer.
Screen protection: If the settings on a working heater are not adjusted
for 2 minutes, the LED display will go out but ON will stay on. It will
light up again when you press a button. If the heather is switched off
using the ON/OFF button, the OFF screen will stay on.
Using with the remote control
The remote control (5) has the same 6 buttons as the operating panel
(MOD = MODE) and works in roughly the same way, but:
 You cannot use the remote control (under M-mode) to set
the capacity with the + or - buttons. Use
the bar button for this purpose.
 The remote control has an ECO button for an energy
efficient mode; the heater maintains the room at 16°C. The
screen shows EC. Deactivate by pressing ECO again.
Nothing else can be set under this setting.
If the heater is working on ECO setting and a timer setting becomes active, the
heater will start to work according to the timer setting. When the heat goes off, the
heater will not return to the ECO setting, but go off.
Working with the app via wifi
The heater can also be operated using an app on your smartphone. The heater must
be connected with a wifi modem. See the back of the booklet for instructions on how
to install the app. By activating the app on your smartphone or tablet, and selecting
the device, you can operate the heater with the smartphone. You do not need to set
a day or time as they are set automatically (both on the app and on the display).
You can use the app to switch the device on and off (without anticipation), regulate
the temperature and capacity, and set the ECO setting. The app can also be used to
set 20 on and off settings daily, on the weekly timer.