Operation Manual

OPERATION

Dry vacuum cleaning:

 Check to ensure that the dust bag is installed

correctly in the body of the device. Close the

body of the device properly with the clamps.

 Insert the hose as far as it will go into the hose

connector: you may turn it until the catch falls

into the recess. Then turn it a quarter clockwise.

 After this, connect the accessories you wish with

a twisting force.

 Insert the plug into the socket.

 Press the ON-switch (I) to turn on (and press

later on the off-switch (O) to turn off).

 You can adjust the airflow by pushing the sliding block 1B up and down.

Wet vacuum cleaning:

 For the vacuuming of liquid the motor (which is situated in the cap) is provided with a

floater that is hanging under the motor, in the barrel. For the vacuuming of liquid the

motor is provided with a filter that the floater surrounds and in that way prevents that

objects enter the mechanic system. Never vacuum liquid without the filter around the

floater!

 Be carefull!

 Never vacuum dust without the dust bag!

 Never vacuum liquid with the dust bag!

 Never vacuum liquid without the filter around the floater!

Blowing

By connecting the suction hose to the blower opening (instead of the hose connector)

you can blow instead of vacuuming. Operation is otherwise the same.

CLEANING UP

Switch the device off and remove the plug from the socket. Place the accessories at the

appropriate locations on the device, see image.

CLEANING AND MAINTENANCE

Before cleaning or maintenance: always switch off the equipment and unplug it.

Emptying dust bag

Open both the locking blocks (4) en take the up housing from the vacuum cleaner.

Remove the dust bag from the body of the device and open by sliding the plastic clamp

off. Empty the dust bag, shake it until it is clean and connect once again. Replace in the

device correctly. At the end, place back the up housing and close the locking blocks.