Operation Manual

11
OPERATION
 Put the machine-connection of the hose in
the machine till the narrow part is in total in
the machine and clicks. Pressing the ribbed
clamps on the connector will enable you to
disconnect the hose.
 After this, connect the accessories you wish
with a twisting force, see picture.
 For the vacuuming of liquid the motor (which
is situated in the cap) is provided with a
floater that is hanging under the motor, in the
barrel. For the vacuuming of dry dirt and dust
the motor is provided with a filter with a
basket that the floater surrounds and in that
way prevents that dust enters the mechanic
system (see picture). Do you want to vacuum
liquid, remove than the filter wit basket by
opening the locking blocks, to lift and turn the
cap and remove the filter with basket. Bring
the cap back in its position and close the
blocks.
 Be carefull!
 Never vacuum dust without the filter with
basket around the floater!
 Never vacuum liquid with the filter with
basket around the floater!
 Insert the plug into the socket.
 Press the switch on/off to I to turn on. Type 1240 has 1 switch which is used to engage
the power. Type 2070 has 2 switches, type 3080 has 3 switches; each switch
corresponds to 1000w of power.
 After use, switch the device off by pressing the switch(es) on/off to O and remove the
plug from the socket. Wind the electrical cable around the cable hanger. Type 1240:
Place the accessories at the appropriate locations behind the device.
SAFEGUARDS
If you are sucking up water and the container is full, a float will cut off suction. The motor
will produce a noise that sounds like high revs but, in fact, the machine will no longer
suck effectively. In this event, switch the unit off and remove the plug from the socket.
Empty the container; you can then carry on using the device as normal.