Operation Manual

14
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is grounded.
If everything is all right you can insert the plug into the socket.
The Golden Shadow has a remote control that works with 2 AAA batteries (not oncluded). While
using, point the remote control to the receiving point of the heater. If there are obstacles
between remote control and the heater, it will not work!
Remove the batteries out of the season, that will extend the life of the remote control.
 Press the main switch (8) at the side of the device to ‘I’ (ON). The red indicator light (6) light
up (standby-modus).
 Subsequently, press the red ON/OFF button on the
remote control (X). The red indicator light (6) turns
green and the device will operate at half capacity: it
hardly diffuses light!
 If required, press the full-capacity button (Z). The
second green light will also light up; the device will
operate at full capacity and diffuses a minimal glow.
 To reverse to half capacity, press the half-capacity
button (Y). The second green light will turn off and the
device will operate at half capacity.
 By pressing the ON/OFF button again, you switch off
the device (standby modus).
 The device can also be used without the remote control
by using the ‘manual operation’ button (7). To that end,
press the main switch to ‘I’; each time you now press
the ‘manual operation’ button, the device will switch from standby to half capacity to full
capacity to standby to half capacity, etc. The corresponding indicator lights will light up.
 You only switch off the device permanently by resetting the main switch on the device to ‘O’
(OFF).
Warning! When you turn off the unit using only the remote control, the 'standby' remains. So
turn it off using the remote control or the on/off-switch and remove the plug from the socket!
Allow sufficient time for the device to cool down before you move or maintain it. Pull the plug out
of the wall socket if you do not use the device.
When you use the appliance for the first time (or after a long time again), observe it during the
first 10 till 15 minutes to be sure that is works trouble-free.
CLEANING - MAINTENANCE - SERVICE
Cleaning
This appliance consist of a robust and maintenance-free casing (aluminium with plastic) with a
safety grill.
Before cleaning remove the plug from the power outlet and wait until the appliance is sufficiently
cooled off. Wipe the appliance only with a clean and lint-free cloth or a soft brush. Never use
abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning! Never use flammable
cleaners such as benzene or spiritus. Give the appliance time to dry before you use it again.
To protect against electrical shock and danger of life, do not immerse cord, plug or any part of
the appliance in water or other liquid.