Technical information

CLEANING AND MAINTENANCE
Replacement of the oven light
bulb
In order to avoid the possibility of an
electric shock ensure that the appliance is
switched off before replacing the bulb.
Set all control knob to the position “0”
and disconnect the mains plug,
Unscrew and wash the lamp cover
and then wipe it dry.
Unscrew the light bulb from the socket,
replace the bulb with a new one
– a
high temperature bulb(300 C
) with the
following paramet
ers:
- Voltage 230V
- Power 25 W
- thread E 14.
Oven light bulb
Screw the bulb in, making sure it is
properly inserted into the ceramic
socket.
Screw in the lamp cover.
Door removal
In order to obtain easier access to the oven
chamber for cleaning, it is possible to
remove the door.
To do this, tilt the safety catch part of the
hinge upwards. Close the door lightly, lift
and pull it out towards you. In order to fit
the door back on t
o the cooker, do the
inverse. When fitting, ensure that the notch
of the hinge is correctly placed on the
protrusion of the hinge holder. After the
door is fitted to the oven, the safety catch
should be carefully lowered down again. If
the safety catch is not set it may cause
damage to the hinge when closing the
door.
Tilting the hinge safety catches
Door removal
Removal of the internal glass
panel
Unscrew and unfasten the plastic latch that
is in the corner at the top of the door. Next
take out the glass from the second
blocking mechanism and remove. After
cleaning, insert and block the glass panel,
and screw in the blocking mechanism.
Removal of the internal glass panel
Regular inspections
Besides keeping the cooker clean, you
should:
● Carry out periodic inspections of the
control elements and cooking units of the
cooker. After the guarantee has expired
you should have a technical inspection of
the cooker carried out at a service centre
at least once every two years.
● Fix any operational faults.
● Carry out periodical maintenance of the
cooking units of the cooker.
Caution!
All repairs and regulatory activities should
be carried out by the appropriate service
centre or by an appropriately authorized
fitter.
OPERATION IN CASE OF EMERGENCY
In the event of an emergency, you should:
switch off all working units of the oven
disconnect the mains plug
call the service centre
some minor faults can be fixed by referring to the instructions given in the table below.
Before calling the customer support centre or the service centre check the following
points that are presented in the table.
PROBLEM REASON ACTION
1. The appliance does not
work.
Break in power supply. Check the household fuse
box; if there is a blown fuse
replace it with a new one.
2. The oven lighting does
not work.
The bulb is loose or damaged. Tighten up
or replace the
blown bulb
(see Cleaning
and
Maintenance)
CLEANING AND MAINTENANCE
15
14