User Manual

Page 17 EEF54W / EFF54S Upright Cooker User Manual
INSTALLATION SEQUENCE
(Refer to diagram relating to minimum Clearances required for correct installation)
• Determine position of cooker and ant-tilt plate.
• Securely x the anti-tilt plate to the oor with appropriate fasteners.
• Fasten the stability bolt bracket to the front frame with the 2 screws supplied.
• Reposition the cooker back into the anti-tilt plate and then mark the position of the stability bolt hole.
• Pull the cooker back out and drill the bolt location hole. Use a 10mm masonry or wood drill, depending on
oor type. When drilling into concrete ensure a minimum hole depth of 30mm.
• Reposition the cooker back into the anti-tilt plate, aligning the stability bolt bracket with the 10mm drilled hole.
Then slide the bolt through the bracket and into the hole.
• Connect Electricity supply but do not turn on until installation is completed.
• Slide the cooker back into the anti-tilt plate so that rear cover rests against the rear wall. Then check the height and
level of the cooker. If required, pull the cooker back out and adjust the leveling feet as required.
AMBRY INSTALLATION
Only a qualied person in compliance with the instructions provided must install the appliance.
manufacturer declines all responsibility for improper installation, which may harm persons and damage property.
Important
The power supply to the appliance must be turned off before any adjustments or maintenance work is to be carried out
on the cooker. Air vents at the rear of the cooker should not be fully covered otherwise ventilation will be restricted and
cause possible damage to the cooker.