User Manual Fixed Rangehood R60FS, R60FW, R90FS & R90FW
CONTENT Safety Information and Warnings Installation Instructions Operation Instructions Care and Maintenance Trouble Shooting
Safety Information and Warnings ● ● ● ● ● ● Please ensure this manual is read carefully before installation and use. Keep this manual in a safe and accessible location should future reference be required. The installation work must be undertaken by a qualified and competent fitter. The manufacturer disclaims all liability for any damage or injury caused as a result of not following instructions for installation contained in the following text.
Installation Instructions Method one: 1. The cooker hood should be placed at a distance of 65-75cm from the cooking surface for best effect. The Australian authority requirement is the distance from the highest part of a gas cooktop is 600mm and electric cooktop is 650mm to the bottom of the range hood 2. To install onto the wall, drill 4 holes of Ø 8mm at a suitable place according with the centre distance of hole in the back of the cooker hood. 3. Insert the nut into the holes. 4.
60cm 90cm Notice: There are 2 methods for ventilation, including ' horizontal ventilation' and ' vertical ventilation'. Please pay attention to the ventilation method when installation. 1. Horizontal ventilation: As pic. A shown, please use the cover to seal the outlet on the top, then the air can be vented from back. 2. Vertical ventilation: As pic B shown, please use the cover to seal the outlet on the back, then the air can be vented from top.
Operation Instructions 1. Outdoor air ventilation: Turn the adjuster to outdoor position (pic A), install the outlet, turn on the cooker hood, then the air will be vented from the outside outlet. 2. Indoor air ventilation: Turn the adjuster to indoor position (pic B), install the outlet cover, turn on the cooker hood, then the air can be vented from the inside outlet. When you choose “front re-circulation mode”, the charcoal filter must be installed. 1. Push stop button, and the motor will stop. 2.
Care and Maintenance 1. The rangehood and its filter mesh should be cleaned regularly in order to keep in good working order. Because the grease filters are made of metal, do not clean the filters with detergents that will corrode metal products. 2. Clean the filters as below: Method one: Put the filter in water (40o-50o), pour in some grease-loosening detergent, soak it for about 2-3 minutes and then clean it with a soft brush. Do not brush too hard, as it may damage the filter.
Trouble Shooting Fault Cause The leaf blocked Light on, but motor does not work The capacitor damaged The motor jammed bearing damaged The internal with of motor off or a bad smell from the motor Solution Get rid of the blocking Replace capacitor Replace motor Replace motor Beside the above mentioned, check the following: Light does not work, motor does not work Light damaged Power cord looses One way valve and the air ventilation entrance are not tightly sealed Oil leakage Leakage from the connecti
