600mm Glass Canopy Manual MODEL EUC60GS - Glass Installation and Operation
IMPORTANT: THIS APPLIANCE MUST BE INSTALLED AND SERVICED BY A LICENSED ELECTRICIAN IMPORTANT: PLEASE READ FULLY PRIOR TO INSTALLATION OR OPERATION • • • • • • • • • This canopy rangehood is an indoor appliance and has been manufactured and tested to comply with Australian Standard/New Zealand AS/NZS3350 with Electrical Approval Number V06076. Always switch power off prior to installing, servicing or cleaning the appliance. Never use the appliance without filters.
INSTALLATION Notes • • • • • • • Prior to installation. Please ensure that any existing or proposed roof ducting installation for connection to this appliance is suitable and complies with local municipal building codes and other statutory / building regulations. If you are unsure, please check with appropriate authorities or a qualified roof ducting installer. Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air is fulfilled.
. Fix the flue (top section) bracket (see figure 1c below) into the correct position on the wall using the supplied self-tapping (nylon type) fixing screw sets. 5. Fix the unit body mounting bracket onto the wall to the exact position using the three supplied ‘wall mate’ type self-drilling (metal type) screws sets (consisting of 1 x screw-in socket and 1 x 30mm flathead screw per set). For instructions on how to install the ‘wall mate’ screw sets, contact the manufacturer.
13. To assemble the glass canopy: 13.1. For model EUC90GS & EUC60GS only (See Figure 3c) Slide the glass over the body at the base of the flue section and match the screw holes on the glass to the screw holes on the ranghood. Insert rubber plugs into the holes and insert screws. Screw securely into place. Do not screw too tightly as this may damage the glass. 14. Remove protective plastic film. 15.
To install the carbon filter: Place the carbon filter onto the side end of the fan. To place into proper position, match the slot (which is located around the side of the carbon filter) to the pin on the side of the fan. Turn the filter in an anticlockwise direction (from “B” to “A” on the left hand side, and from “A to “B” on the right hand side) until a ‘click’ is heard, to lock into position. Repeat this step to install the remaining carbon filter on the other side of the fan.
Electrical Distributors of Australia Pty Ltd 8 / 92A Mona Vale Road WARRIEWOOD NSW 2102 AUSTRALIA Tel: (02) 9999 2124 Fax: (02): 9999 1684 WARRANTY CERTIFICATE – Customer Copy MODEL No.:____________________________________ SERIAL No.
