DISHWASHER SI14BM
Please read this user manual first! Dear Customer, We hope that you get the best results from the product which has been manufactured in state-of-the-art plants and passed through a strict quality control procedure. Therefore, please read the entire user manual carefully before using the product and keep it as a reference for future use. In case of transferring the product to someone else, give the manual as well. The user manual will help you use your product in a fast and safe way.
Congratulations on purchasing your new Euromaid product. It is important that you read through the following use and care manual thoroughly to familiarize yourself with the installation and operation requirements of your appliance to ensure optimum performance. Our Customer Care Centre ensures you get the most out of your appliance. For any after sales service please contact our Customer Care team on 1800 444 357 or email service@hapl.com.au and one of our Customer Care Team will get back to you.
CONTENTS 1. Dishwasher 3 2. Important safety instructions 5 3. Installation 7 General safety Intended use Children’s safety 5 5 6 Appropriate installation location Connecting water supply Connection to the drain Adjusting the feet Aquasafe+ Electrical connection Initial use Disposing of packaging material Transportation of the product Disposing of the old product 7 7 8 9 9 9 9 10 10 10 4.
1 Dishwasher Overview 15 1.Upper basket with rack 2.Upper impeller 3.Lower impeller 4.Filters 5.Lower basket 6.Control panel 7.Door 8.Detergent dispenser 9.Silverware basket 10.Lower impeller slot 11.Upper basket rail 12.Ceiling silverware basket 13.Tabletop (depends on the model) 14.Ceiling impeller 15.
Technical specifications This product complies with the following EU directives: Development, production and sales stages of this product comply with the safety rules included in all pertaining European Community regulations. 2006/95/EC, 2004/108/EC, 93/68/EC Capacity Power input Total power consumption Heater power consumption Total current Drain pump power consumption Water pressure 14 standard place settings 220-240 V, 50 Hz 1800-2100 W 1800 W 10 A 30 W 0.3 –10 bar (= 3 – 100 N/cm² = 0.03-1.
2 Important safety instructions This section contains safety instructions that will help to get protected from risk of personal injury or property damage Failure to follow these instructions shall void all warranties. General safety • Never place the product on a • • • • • • • • carpet-covered floor; otherwise, lack of airflow beneath the product will cause electrical parts to overheat. This will cause problems with your product.
• • • The manufacturer waives any responsibility arisen from incorrect usage or transportation. The service life of your product is 10 years. During this period, original spare parts will be available to operate the appliance properly.
3 Installation Refer to the nearest Authorised Service Agent for installation of your product. To make the product ready for use, make sure that the electricity, tap water supply and water drainage systems are appropriate before calling the Authorised Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out.
09 A Open the taps completely after making the connections to check for water leaks. For your safety, close the water inlet tap completely after the washing programme is over. Connection to the drain 1011 Water discharge hose can directly be connected to the drain hole or sink’s drainage. The length of this connection must be min. 50 cm and max. 100 cm from the floor.
C Drainpipe must be connected to the sewage system and it should not be connected to any surface water. Adjusting the feet If the door of the product cannot be closed properly or if the product swings when you push it slightly, then you need to adjust the feet of the product. Adjust the feet of the product as illustrated in the installation manual supplied with the product. Aquasafe+ (depends on the model) Protect the Aquasafe+ system against water leaks that may occur at hose inlet.
C detergent while the machine is empty. Some water might have remained in the product due to the quality control processes in the production. It is not harmful for the product. Disposing of packaging material Refer to your local dealer or solid waste collection centre in your area to learn how to dispose of your product. A For children's safety, cut the power cable and break the locking mechanism of the door so that it will be non-functional before disposing of the product.
4 Prewashing Tips for energy saving 1. Push the latch to right to open the detergent dispenser lid (A). Following information will help you use the product in an ecological and energy-efficient manner. · Wipe away any coarse food remnants on the dishes before putting them in the product. · Operate the product after filling it completely. · When selecting a programme, refer to the “Programme Table”. · Do not put more detergent than suggested on the detergent package.
C In programmes with prewash and at C A high temperature, in which you use tablet detergents, make sure that the detergent dispenser lid is closed firmly. Use powder detergent in short programmes without prewash since the solubility of the tablet detergent changes depending on the temperature and time. Excessive usage of powder detergents will cause the detergent not dissolve completely and will also cause scratches on the glassware. 2. Fill the reservoir until “MAX” level. 3.
C Decorative prints of chinaware as well as aluminum and silver items may get discoloured or tarnished after washing in the dishwasher just as it happens in handwashing as well. Some delicate glass types and crystals may become dull in time. We strongly recommend you to check if the tableware you are going to purchase is suitable for washing especially in the dishwasher.
Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware 14 EN
Silverware basket (depends on the model) Silverware basket is designed to wash your dishes such as fork, spoon and etc. in a cleaner manner. Movable silverware basket (depends on the model) Since the cutlery basket can be moved (A, B), you can create a wider space while placing your dishes to the lower basket and free up space for your dishes in different sizes. 1029_redaksiyon 4-3B Tall Tub cutlery basket Silverware basket piece (depends on the model) You can place your forks, spoons and etc.
Collapsible lower basket wires (2 pieces) (depends on the model) The two piece foldable wires located at the lower basket of the machine are designed for an easier placement of large pieces such as pans, bowls, etc. (1, 2). You can create larger spaces by folding each wire individually or all of them at once. Lay the foldable wires down by pressing on the latch (A).
Collapsible lower basket wires (6 pieces) (depends on the model) The foldable wires (A) located at the lower basket of the machine are designed for an easier placement of large pieces such as pans, bowls, etc. You can create larger spaces by folding each wire individually or all them at once. To bring the collapsible wires into horizontal position, grab the wire from mid position and push them in the directions of arrows (B) To bring the wires back to vertical position, just lift them up.
Collapsible lower basket wires (4 & 8 pieces) (depends on the model) The foldable wires (A) located at the lower basket of the machine are designed for an easier placement of large pieces such as pans, bowls, etc. You can create larger spaces by folding each wire individually or all them at once. To bring the collapsible wires into horizontal position, grab the wire from mid position and push them in the directions of arrows (B) To bring the wires back to vertical position, just lift them up.
Lower basket multipurpose / height adjustable service rack (depends on the model) This accessory located at the lower basket of the machine allows you to easily wash pieces such as extra glasses, long ladles and bread knives. To close the racks: 1. Fold the rack (A). 2. Slide the rack up (B). 3. Put the rack in vertical position (C). 4. Slide the rack down and lock it with the tabs (D). Perform the same process in reverse order to open the racks. To adjust the height of the racks: 1. Fold the rack (E). 2.
Lower basket bottle wire Upper basket drawer (depends on the model) The bottle wire is designed for easier washing of long pieces with wide mouths. You may take out the bottle wire from the basket when not in use by pulling it out from both sides (H). (depends on the model) You can easily place additional desert spoons, small forks and knives into the basket drawer installed to the upper basket of your machine.
Upper basket glass support piece (depends on the model) When placing long stemmed glasses or wine glasses, do not lean them against other pieces but to the edge of the basket or to the rack (1). Do not lean long glasses against each other. They can move and get damaged during washing. If you wish to place large-volume pieces on the upper basket, release the tab of the glass support piece from the upper basket wire it is hooked to. Thus, you can obtain a wider space.
Collapsible upper basket wires (depends on the model) There are collapsible wires on the upper basket of the machine that you can lay down when you need a larger room for big dishes. On your upper basket there are two types of collapsible wires namely, fully laid system (A) and gradually laid system (B). To bring the collapsible wires into horizontal position, push the wires in the direction of the arrow by holding them from the middle. You can place your larger dishes into the area created.
Adjusting the height of loaded upper basket (depends on the model) Basket adjustment mechanism on the upper basket of the machine is designed to allow you create wider areas in the upper or lover section of the machine based on your requirements by adjusting the height of the loaded basket in up or down directions without removing it from the machine. To raise the basket: 1. Grab one of the upper basket wires (right or left) and lift it up (A). 2.
Adjusting the height of loaded upper basket (depends on the model) Basket adjustment mechanism on the upper basket of the machine is designed to allow you create wider areas in the upper or lover section of the machine based on your requirements by adjusting the height of the loaded basket in up or down directions without removing it from the machine. To raise the basket: 1. Grab one of the upper basket wires (right or left) and lift it up (A). 2.
Adjusting the height of empty upper basket (depends on the model) You can adjust the height of the upper basket according to the size of the dish to be washed. Use basket rollers to change the basket height. 1. Turn the stoppers on the ends of the upper basket rails by turning them aside (A). 2. Take the basket out (B). 3. Change the position of the rollers, place the basket into the rail and close the stoppers (C).
Ceiling silverware basket Ceiling silverware basket is designed to wash small items or items that are too long to fit into the lower silverware basket. Since it can be removed from the machine easily, it allows taking out the dishes from the machine together with the basket after they are washed. It is compatible with all standard drawer sizes and can be placed into kitchen drawers and racks. Thus, there is no need to take the dishes out of the basket and lay them anymore.
5 Maintenance and cleaning Service life of the product extends and frequently faced problems decrease if it is cleaned at regular intervals. A Unplug the product and turn off the tap before attempting any cleaning procedures. C Do not use abrasive substances for cleaning. C Clean the filters and impellers at least once a week. 1. Turn the micro filter (3) and coarse filter (2) assembly counter clockwise and pull it out from its seating (A).
3. Press the two pawls on the coarse filter inwards and separate the coarse filter from the assembly (C). Cleaning the impellers Clean the impellers at least once a week in order for the machine operates efficiently. Lower impeller Check if the holes on the lower impeller (1) are clogged. If they are clogged, remove and clean the impeller. Pull the lower impeller up to remove it (A, B). 4. Clean all three filters under tap water by means of a brush. 5. Replace the metal/plastic filter. 6.
Upper impeller Check if the holes on the upper impeller (2) are clogged. If they are clogged, remove and clean the impeller. Turn its nut to left to remove the upper impeller (C, D). Make sure that the nut is tightened well when installing the upper impeller. Ceiling impeller Check if the holes on the top ceiling impeller (3) of your machine are clogged. If they are clogged, remove and clean.
6 Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. • Door of the machine is open. >>> Make sure that you have closed the door of the machine. • On / Off button is not pressed. >>> Make sure that you have turned on the machine by pressing the On / Off button.
Dishes are not dry at the end of cycle • Dishes are not placed orderly in the machine. >>> Place your dishes in a way that no water will accumulate in them. • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the machine. • Machine is unloaded right after the programme is over. >>> Do not unload your machine right after washing process is completed.
There is a different odour in the machine C A new machine has a peculiar odour. It will fade out after a couple of was- hing. • Filters are clogged. >>> Check if the filter system is clean. Clean the filter system regularly as illustrated in section "Cleaning and Care". • Dirty dishes are kept in dishwasher for 2-3 days. >>> If you are not going to start the machine right after you have put the dishes into it, remove the remnants on the dishes and run the Prewash programme without detergent every 2 days.
Detergent remains in detergent dispenser. • Detergent dispenser was damp when adding detergent. >>> Make sure that the detergent dispenser is dried well prior to filling it with detergent. • Detergent is added long before the washing process. >>> Pay attention to add detergent shortly before start-up of the washing. • Opening of the detergent dispenser lid is prevented during washing.
Foam forms in the machine. • Dishes are washed with hand-wash detergent by hand but not rinsed before placing them into the machine. >>> Hand-wash detergents do not contain antifoam. There is no need to hand-wash the dishes before placing them into the machine. Removing the coarse soil on the dishes under tap water, with a tissue paper or fork will be sufficient. • Rinse aid has spilled into the machine when adding rinse aid.
EN 17 8998 01 00_AA
