Manual

DISASSEMBLY (TAKE-DOWN) INSTRUCTIONS
Pull slide back as far as possible. Lift the rear of
slide upward and while holding it in this position,
allow the recoil spring to slowly pull it forward over
barrel. Remove recoil spring assembly.
Unload chamber
lnsc
that
rect chamber to assure
gun is empty
Place thumb safety
in position
so that “S”
is showmg
.,x Cock hammer
10 Remove magazine
DISASSEMBLY (TAKE-DOWN) INSTRUCTIONS:
1. Unload chamber, Remove magazine, Inspect chamber to assure that gun is empty.
2. Place thumb safety in position so that “S” is showing.
3. Cock hammer.
4. Pull slide back as far as possible. Lift rear end of slide upward and while holding
it in this position, allow the recoil spring to slowly pull it forward over barrel.
Remove recoil spring assembly.
ASSEMBLY INSTRUCTIONS:
1. With magazine removed, place thumb safety lever in forward safe position and
cock hammer.
2. Insert recoil spring assembly in position under barrel with small end under
muzzle and large end toward trigger.
3. Slip slide over muzzle with recoil spring assembly small end in round slide hole
and pull slide to rear as far as possible. Push rear end of slide down and allow it
to go forward into assembled position.