Owner`s manual

Page 13
DV 42 ST See-through Gas Fireplace
rev.110308
Installation
Removing and Installing the Doors
Removing the doors
The doors are removed in a few simple steps. Follow these steps below to remove
the horizontal access panel, unlatch the door buckles and, remove the door. Replace
in reverse order.
Figure 28a. Locate the door buckles, both sides typical
Door Latch Hook
Door Latch Slot
Hand-hold
Release the Door Buckles
Figure 28. Removing and installing the the horizontal access panel
Locate the Door Buckles
Figure 28b. Door Buckle Tool
1
Step 4:
Firmly grasp hand-hold end
of door buckle tool and place
the machined end in the slot
under door frame, as shown.
Figure 28c.
Step 2:
Step 3:
Step 1:
Remove the horizontal cover by
placing ngers in both nger holes,
then pushing away from you and
lifting out. Place it aside during
maintenance or cleaning. Install in
reverse order.
Installed Gas
Valve Cove
r
Finger Holes
Remove the Horizontal Access Panel
DV 42 ST
To install the door, hook the top edge of the door frame into place. Lower the door
into position and follow the previous steps shown in reverse order.
Installing the Door
2
Step 5:
Ensure the tool is rmly in the
lower end of the slot, as shown,
then pull toward you.
Caution: The latch springs
back with force, hold the tool
securely.
3
Step 6:
Pull hard if necessary to release
the spring tension.
Caution: The latch springs
back with force, hold the tool
securely.
4
Step 7:
Remove the tool from the latch
slot. Ensure the latches are
hanging freely, the hook end is
released from the bottom of the
door. Repeat all four steps for the
remaining latches.
Figure 28d.
Figure 28e.
Figure 28f.
Step 8:
Grasp the door on either side, usually midway and lift upward, lift the door
carefully up and away from the front of the replace. See Figures 28g. Place the
door aside in a safe place while maintenance and/or cleaning is being performed.
Figure 28g. Removing and installing the glass doors, both sides typical.
Removing the Door