Owner`s manual

Page 10
DV 42 Indoor Gas Fireplace
Installation
Figure 11c. Rear vent, roof mounted venting (one 90° bend).
Section 3-2-2: VENTING COMPONENTS
Select from the following components and associated European Home part
numbers for installation of a Roof Mounted Termination. Use only European
Home Vent Components. Use of non-European Home parts will void the
warranty and may impede operation of the replace.
Support ring
Support plate
32’ max
MEXT Sections
Termination
12”
Max.
Connection and installation of the vent components should adhere to the following:
• Use any combination of rigid and ex pipe as required.
• Flex sections may be stretched up to 50% of their total length. For
example, a 24” section maybe stretched to 36”.
• Connect all vent sections using a minimum of three sheet metal screws on
the outer pipe ue.
• Ensure the pipe ends male to female slide in a minimum of 1½” of
overlap.
• Ensure all runs are supported with a minimum of 3 supports per 10’ of
venting.
• When hanging/ supporting venting, ensure that 1” clearance is
maintained on sides and bottom of vent runs and 2” above horizontal
vent runs to any combustible material.
• Ensure when cutting sections of rigid pipe to maintain integrity of
internal supports.
• Place the springs, supplied with the pipe kit, between the outer and inner
pipes to keep the pipes separate and avoid any possible hot spots.
• European Home recommends the use of a ex section for the nal
pipe connected directly to the replace oering greater exibility of
installation and absorption of movement.
• When penetrating a combustible ceiling, a ceiling restop must be used.
• European Home recommends that all exterior corners and joints be
sealed with exterior caulking, however, we encourage you to consult
your Building Envelope Engineer or Waterproong Consultant for further
recommendations.
A - Termination PVTK-1
B - Flex Sections PFL - 1 (12" f/f Section)
PFL - 18 (18" f/f Section)
PFL - 2 (24" f/f Section)
PFL - 3 (36" f/f Section)
PFL - 4 (48" f/f Section)
PFL - 6 (72" f/f Section)
C - Rigid Sections PXT - 5 (5" f/f Section)
PXT - 12 (12" f/f Section)
PXT - 20 (20" f/f Section) PEXT -
1 (12" f/m Section)
PEXT - 2 (24" f/m Section)
PEXT - 3 (36" f/m Section)
PEXT - 4 (48" f/m Section)
PEXT - 6 (72" f/m Section)
D - Support Ring and
Plate
PSPXT-8
E - Firestop FS-8
F - Roof Flashing PRF-7 (1/12 - 7/12 pt.)
PRF-12 (7/12 - 12/12 pt.)
PVTK1