Owner`s manual

Page 13

DV 42 Indoor Gas Fireplace

Installation

Figure 16. Corner installation.

Figure 16a. Flex installation. Allowed for NG Models ONLY.

45° Corner Installation.

Attach an PEL-45 (45° elbow) directly onto the ue collar. Cut the PXT-20 to suit, and

attach it to the PEL-45. Slide the replace into position and attach to the termination.

45° or less Corner Installation.

Use an PTO-4 termination and an PFL-1 or PFL-2/PFL-2 (12" or 24" compressed

length) and a frame, if appropriate. Flex may be turned to obtain desired degree

of angle required but must not exceed 45°.

Note: Through the wall venting kits are also available for both the

straight and the corner installation. The kit includes a heat shield, a PFL-12

(f/f) exible pipe, and a termination with or without a mounting frame.

PEL-45 Elbow

PEL-90 Elbow

PXT-18

Heat Shield